For Windows - Cisco M690 Quick Start Manual

Temporarily Change Your IP Address for Remote
Access

For Windows

6
To remotely configure the Cisco M690 using the network connection, you must
temporarily change the IP address of your computer. Alternatively, you can use
the serial console to configure the Cisco M690, without changing the IP address.
If you use the serial console, proceed to section below.
Make a note of your current IP configuration settings as you will need
Note
to revert to these settings after you finish the configuration.
The exact steps depend on your operating system version.
Go to the Start menu and choose Control Panel.
Step 1
Click Network and Internet, then Network and Sharing Center.
Step 2
Click the Change adapter settings link.
Step 3
Right-click Local Area Connection and choose Properties.
Step 4
Click Internet Protocol Version 4, then choose Properties.
Step 5
Note your current settings.
Step 6
Select Use the Following IP Address.
Step 7
Enter the following changes:
Step 8
IP Address: 192.168.42.43
–
Subnet Mask: 255.255.255.0
–
Default Gateway: 192.168.42.1
–
Click OK and OK again to exit the dialog box.
Step 9