Chapter 4 Setting Methods; Setting The Interval Timer Function Of 16-Bit Timer/Event Counter 00 - NEC 78K0S/K 1+ Series Application Note

Sample program (16-bit timer/event counter 00) interval timer

Hide thumbs Also See for 78K0S/K 1+ Series:

Application note (44 pages)

Application note (38 pages)

Table of Contents

This chapter describes the interval timer function of 16-bit timer/event counter 00.

For other initial settings, refer to the

Control Application

Note. For interrupt, refer to the

Generated by Switch Input Application

Program (Low-Voltage Detection) Reset Generation During Detection at Less than 2.7 V Application

For how to set registers, refer to the user's manual of each product (78K0S/KU1+, 78K0S/KY1+, 78K0S/KA1+,

78K0S/KB1+).

For assembler instructions, refer to the

4.1

Setting the Interval Timer Function of 16-bit Timer/Event Counter 00

The following eight types of registers are set when using 16-bit timer/event counter 00 as an interval timer.

A square wave can be output by using the interval timer function when the timer output (TO00 pin output) is

enabled by using the TOC00 register.

• Capture/compare control register 00 (CRC00)

• 16-bit timer capture/compare register 000 (CR000)

• Prescaler mode register 00 (PRM00)

• 16-bit timer output control register 00 (TOC00)

• 16-bit timer mode control register 00 (TMC00)

• Port mode register x (PMx)

• Port register x (Px)

Note

• Port mode control register x (PMCx)

Note To use the TO00 pin as the timer output (outputting square wave with the TO00 pin), set it as follows.

This setting is not required when not using the TO00 pin as the timer output.

78K0S/KA1+ and 78K0S/KB1+ microcontrollers

78K0S/KY1+ and 78K0S/KU1+ microcontrollers