Sensor Units; Shorten Sensor Unit Cable - Axis F34 User Manual

AXIS F34 Main Unit
Hardware Overview
Status LED
Green
Amber
Note
The Network LED can be disabled so that it does not flash when there is network traffic. To configure, go to Setup > System
Options > Ports & Devices > LED. See the online help for more information.
Network LED
Green
Amber
Unlit
Power LED
Green
Amber

Sensor Units

It is recommended to connect the sensor units to the main unit before powering the main unit. If you disconnect a sensor unit, and
connect a different sensor unit, it may be necessary to restart the main unit.

Shorten Sensor Unit Cable

Note
The sensor unit's cable cannot be extended or split.
The sensor unit is delivered with a cable. To shorten the cable follow these steps:
1. Cut the cable to the desired length. Measure from the sensor unit.
2. Strip the plastic outer coating from the end of the cable.
3. Peel back the shield.
4. Flatten the colored wires in the order described below.
1
Brown
2
White/brown
3
Not used
4
Not used
5
White/blue
6
Blue
5. Insert the wires all the way into a shielded 6P6C RJ12 connector.
NOTICE TICE
NO NO TICE
Make sure that the wires stay in the correct order and that the cable shield makes good contact with the connector shield.
Indication
Steady green for normal operation.
Steady during startup and when restoring settings.
Indication
Steady for connection to a 100 Mbit/s network. Flashes for network activity.
Steady for connection to a 10 Mbit/s network. Flashes for network activity.
No network connection.
Indication
Normal operation.
Flashes green/amber during firmware upgrade.
9