Advertisement
W O L F
E L E C T R I C A L
ELECTRICAL SHOCK HAZARD –
Plug into a grounded 3-prong outlet.
Do not remove ground prong.
I M P O R TA N T
Do not use an adapter.
N O T E
Failure to follow these instructions can
result in electric shock, fire or death.
You must follow
all National
Electrical Code
regulations. In
The Wolf gas range requires a 110/120 V AC
addition, be aware
electrical supply to operate the electronic
of local codes and
ignition system. The 6' (1.8 m) power supply
ordinances when
cord provided with the range is equipped with
installing your
a 3-prong, grounded plug for protection
service.
against shock hazard. The service should have
its own 15 amp circuit breaker.
IMPORTANT NOTE: You must follow all
National Electrical Code and gas regulations.
In addition, be aware of local codes and ordi-
nances when installing your services.
16
G A S R A N G E S
R E Q U I R E M E N T S
R E C O M M E N D E D G R O U N D M E T H O D
IMPORTANT NOTE: This appliance must be
properly grounded to avoid shock hazard.
The range is equipped with a 3-prong ground
plug. To minimize possible shock hazard, the
cord must be plugged into a mating 3-prong
ground-type outlet, grounded to conform with
the National Electrical Code, ANSI/NFPA 70
latest edition, or Canadian Electrical Code
(CSA) and all local codes and ordinances.
Refer to the illustration below.
IMPORTANT NOTE: You must have a properly
grounded, 3-prong outlet installed by a quali-
fied electrician. A ground fault circuit inter-
rupter (GFCI) is not recommended and may
cause interruption of operation.
IMPORTANT NOTE: Do not ground to a gas
pipe.
W I R I N G D I A G R A M
The wiring diagram covering the control circuit
is located inside the lower panel, below the
oven door panels.
Grounding Plug
Grounding-Type
Electrical Outlet
Electrical ground
Advertisement
