Brother 885-E33 Operation Manual page 15

Memo
• When the sewing machine is started or the
handwheel is turned after winding the thread
around the bobbin, the machine will make a
clicking sound; this is not a malfunction.
• The needle bar does not move when you slide the
bobbin winding shaft to the right.
CAUTION
• Not winding the bobbin properly may cause
the thread tension to loosen, and may break
the needle.
1
1 Wound evenly
■ For models equipped with the fast bobbin
winding system
1
Place the bobbin on the bobbin winder shaft
so that the spring on the shaft fits into the
notch in the bobbin. Then slide the shaft to
the right.
1 Notch
2 Spring
2
1
Follow steps through
in "Winding the bobbin" to pass the thread
around the pre-tension disk (page 10).
3
Wind the free end of the thread clockwise
around the bobbin five or six times.
2
2 Wound poorly
3
of the procedure
KNOWING YOUR SEWING MACHINE
4
Pull the thread and pass it through the slit in
the bobbin winder seat.
1 Slit (with built-in cutter)
X The thread is cut to a suitable length.
CAUTION
• Be sure to cut the thread as described. If the
bobbin is wound without cutting the thread
using the cutter built into the slit, the thread
may become tangled in the bobbin or the
needle may bend or break when the bobbin
thread starts to run out.
5
(For models equipped with the sewing speed
controller)
Slide the sewing speed controller to the right
(to set the speed to fast).
6
Turn on the sewing machine.
7
Press the foot controller or press
Note
• When using the foot controller to operate
the sewing machine, connect the foot
controller before turning on the machine.
• When the foot controller is plugged in, the
start/stop button is disabled (only for models
equipped with the start/stop button).
8
When the bobbin begins spinning slowly, take
your foot off the foot controller or press
9
Cut the thread, slide the bobbin winder shaft
to the left, and then remove the bobbin from
the shaft.
1
1 Sewing speed
controller
to start.
.
13