Dell SP2008WFPF User Manual page 18

Exit
Brightness/
Contrast
Auto Adjust
Positioning:
Horizontal
Vertical
Image
settings:
Pixel Clock
(Coarse)
Phase (Fine)
Great user manuals database on
Select to exit the Main menu.
Brightness adjusts the luminance of the backlight.
Adjust Brightness first, then adjust Contrast only if further adjustment is necessary.
Push the + button to increase luminance and push the - button to decrease luminance (min 0 ~ max 100).
Contrast adjusts the degree of difference between darkness and lightness on the monitor screen.
Push the + button to increase the contrast and push the - button to decrease the contrast (min 0 ~ max 100).
Even though your computer recognizes your monitor on startup, the Auto Adjustment function optimizes the display settings for use with your
particular setup.
Select to activate automatic setup and adjustment. The following dialog appears on a black screen as the monitor self-adjusts to the current
input:
Auto Adjustment allows the monitor to self-adjust to the incoming video signal. After using Auto Adjustment, you can further tune your monitor
by using the Pixel Clock (Coarse) and Phase (Fine) controls under Image Settings.
NOTE: In most cases, Auto Adjust produces the best image for your configuration.
NOTE: When using DVI, Auto Adjust is not available.
Positioning moves the viewing area around on the monitor screen.
When making changes to either the Horizontal or Vertical settings, no changes occur to the size of the viewing area. The image shifts in
response to your selection.
When making changes to Zoom setting, you can increase or decrease the size of image. The image scale changes in response to your
selection.
Minimum is 0 (-) and maximum is 100 (+).
NOTE: When using DVI source, the Horizontal and Vertical settings are not available.
The Phase, Pixel Clock and Sharpness adjustments allow you to more closely adjust your monitor to your preference. Select Image Settings
in the main OSD menu to access these settings.
NOTE: Pixel Clock controls the number of pixels scanned by one horizontal sweep. If the frequency is not correct, the screen shows
vertical stripes and the images is not proportional.
Use the - and + buttons to make adjustments. (Minimum: 0 ~ Maximum: 100)
If satisfactory results are not obtained using the Phase adjustment, use Pixel Clock (Coarse) and then use Phase (fine), again.
NOTE: This function may change the width of the display image. Use the Horizontal function of the Position menu to center the display
image on the screen.
UserManuals.info
Auto Adjust In Progress