In The Case Of Left Bevel Cut - Makita LS1214 Instruction Manual

22

In the case of left bevel cut

Molding
position in Fig. A
For inside (1)
corner (2)
For outside (3)
corner (4)
Molding
position in Fig. A
For inside (1)
corner
(2)
(3)
For outside
corner (4)
Example:
In the case of cutting 52/38° type crown molding for
position (1) in Fig. A:
• Tilt and secure bevel angle setting to 33.9°
LEFT.
• Adjust and secure miter angle setting to 31.6°
RIGHT.
• Lay crown molding with its broad back (hidden)
surface down on the turn base with its CEILING
CONTACT EDGE against the guide fence on
the saw.
• The finished piece to be used will always be on
the LEFT side of the blade after the cut has
been made.
Table (A)
Bevel angle
52/38˚ type 45˚ type
Left 33.9˚ Left 30˚
Table (B)
Molding edge against
guide fence
Ceiling contact edge should
be against guide fence.
Wall contact edge should be
against guide fence.
Ceiling contact edge should be
against guide fence.
001578
Miter angle
52/38˚ type 45˚ type
Right 31.6˚ Right 35.3˚
Left 31.6˚ Left 35.3˚
Right 31.6˚ Right 35.3˚
001579
Finished piece
Finished piece will
be on the Left side
of blade.
Finished piece will
be on the Right side
of blade.