Advertisement
Quick Links
Location of Controls
CX-90
1.0 1.0
12
1
LCD screen
2
Volume +/- Button
3
Memory Button
4
DBBS Button
5
Band Button
6
Preset Button
Operations
Make sure that the LOCK switch is slid to OFF position.
In standby mode ( Clock Mode), the lCD display the time.
Press the POWER button to turn the radio on.
Manual / Auto Tuning
Press the BAND button to select AM / FM band.
1.
2.
Press the TUNING
1
8
3.
Press and hold the TUNING
1.0 1.0
It will stop searching when a station signal is received.
Memory Setting
9
1.
Tune in the desired station.
2
7
2.
Press the MEMORY button to enter the memory location that is from 1 to 10.
10
3.
Press the TUNING
3
6
4.
Press the MEMORY button again to save the station to the selected
location.
The memory can be preserved up to 40 seconds without power supply.
4
5
To play a memory station, press the PRESET button to select the desired
memory location from 1 to 10.
Time Setting
11
If it's in radio mode, press the POWER button to enter the standby mode in
1.
which the LCD displays the time only.
2.
Press the CLOCK button for about 2 seconds, the hour flashing on the
7
Tuning (
/
) Button
screen, press
or
3.
Press the CLOCK to confirm the hour selection and to move the flashing
8
Clock Button
cursor to minute, press
to confirm.
9
Lock on / off switch
NOTE: When it's in radio mode, press the CLOCK button to view the
10
Power Button
time that will be displayed for 4 seconds.
11
Earphone Jack
Volume Level Setting
12
Battery Door
Press the VOLUME button +/- to increase or decrease the volume level.
DBBS Switch
Press the DBBS button to turn the DBBS boost system on or off. When it's on,
the DBBS will appear on the right side of the LCD.
Headphones
or
button to increase or decrease the frequency.
or
button for 2 seconds to search station.
or
button to select a memory location from 1 to 10.
NOTE :
When the Lock function is on, a lock icon will appear on the left side of
the LCD.
No operations can be carried out in Lock Mode.
Battery Low Indicator appears when the battery voltage drop to 2.30
VDC.
Whenever the backlight is on, it can last 8 seconds.
When you place the batteries, make sure to match the polaries (+/-) to
the markings on the inside of the compartment on the rear of the radio.
to adjust it.
Safety Instructions
or
to adjust the minute, press the CLOCK again
1. Do not expose the unit to high temperature or humidity.
2. Do not subject the unit to severe impact, or place heavy objects on it.
3. Do not use strong detergent or solvent to clean the unit.
4. Do not try to disassemble and repair the device yourself.
5. Do not expose to excessive heat sources.
6. Do not store in dusty areas.
Specifications
15
15
Advertisement
