Assembly; Operation - Ryobi ONE+ PCL600 Operator's Manual

WARNING:
Do not use this product if it is not completely assembled
or if any parts appear to be missing or damaged. Use of
a product that is not properly and completely assembled
or with damaged or missing parts could result in serious
personal injury.
If any parts are damaged or missing, please call 1-800-525-2579 for assistance.
WARNING:
Do not allow familiarity with this product to make you
careless. Remember that a careless fraction of a second
is sufficient to inflict serious injury.
WARNING:
Always remove the battery pack from the product when
you are assembling parts, cleaning, or when not in use.
Removing these energy sources will prevent accidental
starting that could cause serious personal injury.
WARNING:
The radio is not waterproof. Do not submerge in liquid.
Failure to heed this warning could result in serious per-
sonal injury.
NOTICE:
Always refer to the manual for any device recommended
for use as an attachment or accessory. Proper use of any
device, when attached to the radio, is the sole respon-
sibility of the operator. Improper use may damage the
device or the product.
WARNING:
This radio is capable of producing sound levels that can
be dangerous to long-term hearing. Listening to music
at high volume for any period of time can cause noise-
induced hearing loss. The higher the volume, the less time
required before your hearing could be affected.

ASSEMBLY

WARNING:
Do not attempt to modify this product or create acces-
sories or attachments not recommended for use with this
product. Any such alteration or modification is misuse
and could result in a hazardous condition leading to pos-
sible serious personal injury.

OPERATION

APPLICATIONS
You may use this product for the following purposes:
 Receive and play local FM radio
 Charging USB capable devices
 Streaming audio from BLUETOOTH
INSTALLING/REMOVING BATTERY PACK
See Figure 1, page 8.
To install battery pack:
 Place the battery pack in the radio, aligning the rib on the
battery pack with the groove in the battery port.
 Make sure the latches on the battery pack snap into
place and the battery pack is secured to the radio before
beginning operation.
 Depress the latches to remove the battery pack.
NOTE: Always remove battery pack from radio when not
in use.
For complete charging instructions, see the operator's manu-
als for your battery pack and charger.
LCD DISPLAY
The illustrations of the LCD display shown in this manual
are only examples of the frequencies you may see on your
product and are not the exact frequencies that you may
choose to listen to.
When the product is not connected to a power supply, the
LCD display will remain off. If the product is connected to
a power supply and in the ON position, LEDs will light the
display. You can view the frequency and settings in use on
the LCD display.
5 — English
enabled devices
®