Makita 6402 Instruction Manual
10 mm (3/8”) variable speed/reversing drill
Hide thumbs
Also See for 6402:
- Instruction manual (33 pages) ,
- Parts breakdown (2 pages) ,
- Instruction manual (17 pages)
Advertisement
Quick Links
Download this manual
See also:
Instruction Manual
10 mm (318") MODEL 6402
Variable speedlReversIng
Steel
INSTRUCTION MANUAL
Wood
DOUBLE
INSULATION
264
mm
(10-3/8")
1 0
mm
(3/8")
21
mm
l53/64"1
0
-
1,200
~~
~
-
SPECIFICATIONS
1.7
kg
(3.7
Ibs)
*
Manufacturer reserves the right to change specifications without notice.
*
Note: Specifications may differ from country to country.
Advertisement
Related Manuals for Makita 6402
Summary of Contents for Makita 6402
- Page 1 INSTRUCTION MANUAL SPECIFICATIONS Wood Steel (3/8”) l53/64”1 Manufacturer reserves the right to change specifications without notice. Note: Specifications may differ from country to country. 10 mm (318”) MODEL 6402 Variable speedlReversIng (10-3/8”) 1,200 DOUBLE INSULATION (3.7 Ibs)
-
Page 2: Important Safety Instructions
SAFETY INSTRUCTIONS WARNING: WHEN TY PRECAUTIONS SHOULD ALWAYS BE FOLLOWED TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, AND PER- SONAL INJURY, INCLUDING THE FOLLOWING: READ ALL INSTRUCTIONS. KEEP WORK AREA CLEAN. Cluttered areas and benches invite injuries. CONSIDER WORK AREA ENVIRONMENT. Don't use power tools in damp or wet locations. -
Page 3: Additional Safety Rules
"live" wire. Do not leave the tool running. Operate the tool only when hand-held. 6. Do not touch the drill bit or the workpiece immediately after operation; they may be extremely hot and could burn your skin. - Page 4 Installing or removing drill bit CAUTION Always be sure that the tool the bit. To install the bit, place will go. Tighten the chuck by hand. as it Place the chuck key in each holes and tighten clockwise. Be sure to tighten three chuck holes evenly.
-
Page 5: Maintenance
When this occurs, both carbon brushes should be replaced. To maintain product SAFETY and RELlABl LITY, repairs, carbon brush inspection and replacement, any other maintenance or adjustment should be performed by Makita Authorized or Factory Service Centers, always using Makita replacement parts. - Page 6 ACCESSORIES C A U T I O N : These accessories or attachments are recommended for use with your Makita tool specified in this manual. The use any other accessories or attachments might present a risk accessories or attachments should...
- Page 7 06-88 July @ " 10 mm (3/8") DRILL Model 6402 Note: The switch, noise suppressor and other part configurations may differ from country to country.
- Page 8 MAKnA L I M I T E D ONE YEAR WARRAHTY Warranty Policy Every Makita tool is thoroughly inspected and tested before leaving the factory. It is warranted be free of defects from workmanship and materials for the period of ONE YEAR from the original purchore.