Maintenance - Lennox e-Lite Installation And Operation Manual

Floor standing unit
Table of Contents

Advertisement

w
Note that outlet air is cooler or heater than set room temperature.
Avoid direct exposure to outlet air as it may be too cool or hot.
Do not set the
temperature too
Figure 11.3
Maintain a proper air distribution.Air outlet louvers should be used
w
to adjust the direction of outlet airflow, as doing so might ensure
more efficient operation.

12. Maintenance

Caution
Please release pressure before disassembly.
Before you clean the air conditioner, ensure it is powered off.
Check that the wiring is undamaged and connected.
Use a dry cloth to wipe the indoor unit and remote controller.
A wet cloth may be used to clean the indoor unit if it is very
dirty.
Never use a damp cloth on the remote controller.
Do not use a chemically treated duster on the unit or leave this
type of material on the unit to avoid damaging the finish.
Do not use benzene, thinner, polishing powder, or similar
solvents for cleaning. These may cause the plastic surface to
crack or warp.
w
Method for cleaning the air filter
a. The air filter can prevent the dust or other particles from
entering the unit. If the filter is blocked, the unit will not work
well. Clean the filter every two weeks when you use it regularly.
b. If the air conditioner is positioned in a dusty place, clean the
filter often.
c. Replace the filter if it is too dusty to clean (the replaceable air
filter is an optional fitting).
low
Figure 11.4
1. Take out the air intake grille
Remove the bolts, push the grille switches simultaneously, as
indicated in Figure 12.1. Then pull down the air intake grille
(together with the air filter, as shown in Figure 12.2). Pull the air
intake grille down to 15°, and lift it up to remove the grille.
15°
Caution
The control box cables originally connected to the electrical
terminals on the main body must be removed, as indicated
above.
2. Dismantle the air filter.
3. Clean the air filter
Dusts will accumulate on the filter along with the unit operation,
and need to be removed from the filter,or the unit would not
function effectively.
Clean the filter every two weeks when you use the unit regularly.
Clean the air filter with a vacuum cleaner or water.
a. The air intake side should face up when using a vacuum
cleaner. (Refer to Figure 12.3)
b. The air intake side should face down when using clean water.
(Refer to Figure 12.4)
For excessive dusts, use a soft brush and natural detergent to
clean it and dry in a cool place.
14
Figure 12.1
Figure 12.2
Figure 12.3

Advertisement

Table of Contents
loading

Table of Contents