Advertisement
Mackie Digital X Bus
Registration of the UAD-1 Card is done between you and Universal Audio. LOUD Technologies
Inc. does not have the means to register your card with Universal Audio, so this is something
you will need to do on your own. It is not required to register your UAD-1 Card, but it is strongly
recommended so you can acquire additional software licenses as needed and receive updates
about newer versions of the UAD-1 software.
Note: Since the Digital X Bus does not have an active connection to the Internet, you will have
to write down all the numbers described below for each UAD-1 card you are using with the
Digital X Bus, and then take those numbers to go register at the Universal Audio website at http:
//www.uaudio.com
Hardware ID Number
To get your Hardware ID number(s), follow the steps listed out in the previous section ("Veri-
fying Proper Installation") to open the UAD Performance Meter. Once it is open, click on the
small folder icon on the right side of the Performance Monitor, and select "Authorizations" from
the pull down menu as shown in Figure P:
Figure P
That opens the UAD-1 Authorization Panel, which displays the Hardware ID Number for each
UAD-1 card you have installed in the Digital X Bus. Make sure you write down each Hardware
ID Number for each UAD-1 Card you have installed, and save it for later.
UAD-1 Serial Number
As mentioned in the "Installing the UAD-1 Hardware" section, your UAD-1 Serial Number is
located on a small barcode sticker that has been applied to the rear side of the actual UAD-1
Card. Hopefully, by this time, you have already written down that number so you don't have to
get back inside the Digital X Bus again. If not, you will need to be able to see the actual card and
read the Serial Number from that sticker. Make sure to write down the Serial Number for each
UAD-1 Card you have installed.
We recommend you keep your Hardware ID Number(s) and your Serial Number(s) in a safe
place in case you need them again in the future.
Registering with Universal Audio
Once you have the codes described above, you need to get on a Mac or as PC connected to the
Internet.
Then, type in http://www.uaudio.com and go to Registration Page. There, you need to follow
all the instructions to register your UAD-1 Card(s). You will also have the option of purchasing
additional software licenses, depending on your needs.
UAD-1 Powered Plugins Installation Guide
Registering Your UAD-1 Card(s)
13
Advertisement
