Advertisement
Available languages
Available languages
Using Your Radio
Operation
Turning On Your microTALK
On/Off Power
To Turn On Your Radio:
1.
Press and hold the
hear a series of audible tones indicating the
radio is On.
Your microTALK
ready to receive transmissions. The radio is
always in
Standby Mode except when the Talk,
Call or Mode buttons
Battery Low
Battery Low
When
battery power is low, the Battery Low icon
will blink. Your batteries should be replaced or
recharged, if using rechargeable batteries.
Auto
Battery Save
Battery Save Mode
Your microTALK
designed to extend battery life. If there are no
transmissions within ten (10) seconds, the radio
will automatically switch to Battery Save Mode
and
Power Saver icon will flash in the display.
This will not affect the radio's ability to receive
incoming transmissions.
Communicating with Another Person
Talk Button
To Talk To Another Person:
1.
Press and hold the Talk
2. With the microphone about two (2) inches (5 cm)
from your mouth, speak in a normal voice.
2 inches (5 cm)
From Mouth
3. Release the Talk
talking and listen for a response.
You cannot receive incoming calls while pressing
the Talk
button.
Both radios must be tuned to
the same channel to communicate.
English
6
®
Radio
Power button until you
®
radio is now in
Standby Mode,
are pressed.
®
radio has a unique circuit
button.
button when you
are finished
Introduction
Mode Button
•
•
Channel Button
•
Channel Number
•
Operation
Customer
Assistance
Scrolling Through
the Mode Function
By
scrolling through the Mode function, you will
be able to select or turn On preferred features of
your microTALK
®
radio. When scrolling through
the Mode function, your radio features will be
displayed in the same predetermined order:
Set Privacy Code
Set NOAA All Hazard Radio Channels
Set NOAA All Hazard Alert
Set Channel Scan
Set Privacy Code Scan
Set Call Tones
Set "Roger Beep" On/Off
Channels
To Select a Channel:
1.
With the radio On, select any of the
22 channels by pressing the
or Channel Down button.
Both radios must be tuned to the
same channel to communicate.
Channels 1 through 7 are shared with FRS/
GMRS. Channels 8 through 14 are FRS only.
Channels 15 through 22 are GMRS only.
See page 17 for FRS/GMRS frequency
allocations and compatibility charts.
Nothing
comes close to a
Warranty
•
•
Channel Up
Cobra
™
7
Advertisement
