Fussion 3000 Specifications; 2000 Mackie Designs Inc. All Rights Reserved. Printed In Italy - Mackie Fussion Series 3000 User Manual

FUSSION 3000 SPECIFICATIONS

System Acoustic
Frequency Range (–10 dB): 45Hz-20kHz
Frequency Response (–3 dB): 55Hz-18kHz
Horizontal Coverage (–6 dB): 80º averaged 2kHz-10kHz
Vertical Coverage (–6 dB): 70º averaged 2kHz-10kHz
Directivity Factor; DI (Q): 10.19 (10.46) averaged
Maximum SPL (long term): 130 dB @ 1m
Maximum SPL (peak):
Maximum SPL (long term—High Pass ON): 132 dB
Maximum SPL (peak—High Pass ON):
Crossover Points:
Dynamic Range:
Phase Response:
Transducers
Low-Frequency Transducers—Four Each
Cone Diameter:
Voice Coil Diameter:
Nominal Impedance:
Power Handling:
Mid-Frequency Transducer
Cone Diameter:
Voice Coil Diameter:
Nominal Impedance:
Power Handling:
High-Frequency Transducer
Diaphragm Diameter: 3˝ (75mm)
Throat Exit Diameter: 1.4˝ (35.6mm)
Nominal Impedance:
Power Handling:
Diaphragm Material:
Power Amplifiers
Low-Frequency Power Amplifier
Rated Power:
Rated THD:
Mid-Frequency Power Amplifier
Rated Power:
Rated THD:
High-Frequency Power Amplifier
Rated Power:
Rated THD:
Audio Input/Output/Controls
Input Type:
Input Impedance:
Sub-Out:
with protection and active monitoring
for FUSSION 1800S/1800SA active
subwoofer system
Fill-Out:
Fill-Out Level:
Fill-Out Phase Control: 0º/180º
High-Pass Switch:
2kHz to 10kHz
133 dB @ 1m
135 dB
500Hz, 2500Hz
> 110 dB
± 35º from 500Hz-10kHz
12˝ (300mm)
3˝ (75mm)
8 ohms each
350 watts rms (long term) 1
8˝ (200mm)
2˝ (50mm)
8 ohms
150 watts rms (long term) 1
8 ohms
75 watts rms (long term) 1
Titanium
1000W continuous @ 8Ω
1500W peak @ 8Ω
< 0.03%
200W continuous @ 8Ω
300W peak @ 8Ω
< 0.03%
100W continuous @ 8Ω
150W peak @ 8Ω
< 0.03%
Balanced differential
50k ohms
85Hz low-pass output
85Hz high-pass output
0 dB to –30 dB
85Hz high-pass to LF
driver
Line Input Power
US:
Recommended Amperage Service:
AC Connector:
Europe:
Recommended Amperage Service:
AC Connector:
In-rush Current Protection:
Safety Features
RMS Limiting:
Thermal Protection:
Physical Properties
Enclosure:
Hanging Inserts:
Rigging Inserts:
Handles:
Height:
Front Width:
Rear Width:
Depth:
Weight:
Options
Active Subwoofer System:
Flyware:
Disclaimer
Since we are always striving to make our
products better by incorporating new and improved
materials, components, and manufacturing methods,
we reserve the right to change these specifications at
any time without notice.
"Mackie," the "Running Man" figure, and
"FUSSION" are trademarks or registered trade-
marks of Mackie Designs Inc.
All other brand names mentioned are trade-
marks or registered trademarks of their respective
holders, and are hereby acknowledged.
©2000 Mackie Designs Inc.
All Rights Reserved.
Printed in Italy.
1 Power handling for transducers is based on an AES long term power
testing standard conducted for 100 hours full power, free air.
115V, 60Hz
20A recommended
3-pin Twistlock
250VAC, 20A male
230V, 50Hz
16A recommended
3-pin IEC
250VAC, 16A male
Transistor-based
Monitoring and limiting
of continuous RMS
output of amplifiers
Input stage shutdown,
auto-reset
Trapezoidal, 15º side
angles, 18mm multi-
layered birch
4 points on top
2 points, 1 each side
ATM MEGS
1 pull-back clip, bottom
4 ea. aluminum/rubber
grips
41.9˝ (1064mm)
24.7˝ (628mm)
13.9˝ (352mm)
22.6˝ (575mm)
246 lbs. (112kg)
FUSSION 1800SA/1800S
ATM MEGS compatible
11