Advertisement
Using Your Radio
Operation
Turning On Your microTALK
On/Off Power
To Turn On Your Radio:
1. Rotate the On/Off Volume knob clockwise
to turn On your radio and adjust the volume.
A series of tones will indicate the radio is On.
Your microTALK
mode, ready to receive transmissions. The radio
is always in Standby mode, except when the
Talk, Call or Mode buttons are pressed.
Battery Low
Battery Low
Your microTALK
that shows when battery power is decreasing.
The greater the number of ascending bars visible,
the stronger the battery level. When the battery
level is low, the last bar and "bALo" will flash
indicating your batteries should be replaced or
recharged, if using rechargeable batteries.
Auto Battery Save
Battery Save Mode
Your microTALK
designed to extend battery life. If there are
no transmissions within ten (10) seconds,
the radio will automatically switch to Battery
Save mode and the Power Saver icon will flash
in the display. This will not affect the radio's
ability to receive incoming transmissions.
English
2
®
Radio
®
radio is now in Standby
®
radio has a battery level meter
®
radio has a unique circuit
Introduction
Talk Button
•
Two (2) Inches [Five
(5) cm] From Mouth
•
Channel Button
•
Channel Number
Listening
Operation
Customer Assistance
Communicating With Another Person
To Talk To Another Person:
1. Press and hold the Talk button.
2. With the microphone about two (2) inches
[five (5) cm] from your mouth, speak in a
normal voice.
3. Release the Talk button when you are
finished talking and listen for a response.
You cannot receive incoming calls while
pressing the Talk button.
Both radios must be tuned to
the same channel/privacy code to
communicate.
Channels
To Select A Channel:
1. With the radio On, select any of the
22 channels by pressing the Channel Up
or Channel Down button.
Both radios must be tuned to the
same channel to communicate.
Channels 1 through 7 are shared with FRS/
GMRS. Channels 8 through 14 are FRS only.
Channels 15 through 22 are GMRS only.
See page 21 for FRS/GMRS frequency
allocations and compatibility charts.
Listening For A Response
When You Are Finished Talking:
1. Release the Talk button to receive incoming
transmissions. Your microTALK
always in Standby mode while the Talk or
Call buttons are not pressed.
Nothing comes close to a Cobra
Warranty
•
•
•
®
radio is
™
3
Advertisement
