Mackie C200 Installation Instructions page 2

4. Attaching the Eyebolt:
The table indicates loudspeaker aiming angles to Eyebolt (E) posi-
tions. A negative angle means the loudspeaker is aimed upwards.
Suspending the loudspeaker horizontally:
5. When suspending horizontally, attach a Hanging
Bracket to both the top and bottom of the loudspeak-
er. Follow step 1 for removing the 4 flat head screws
and handle from the top side of the loudspeaker.
From the bottom side, remove the 4 screws that
hold the pole mounting bracket. The pole mounting
bracket must remain on the loudspeaker as it will be
reattached when the Hanging Bracket is installed.
6. Attach a Hanging Bracket to the top side of the loud-
speaker by following steps 2 and 3.
7. Install 2 Eyebolts to top side Hanging Bracket in "a"
and "e" position (see step 4).
8. Similarly, attach a Hanging Bracket
to the bottom side of the loudspeak-
er noting these differences:
• Install the 2 Eyebolts (E) into the
Hanging Bracket in positions "a" and
"e" (see step 4) before assembling it
onto the loudspeaker.
• Use the Hanging Bracket's 4 inner
mounting holes.
• Position the 4 inner mounting hole
tabs toward the loudspeaker.
9. Adjust the aiming angle by adjusting
the cabling to the 4 Eyebolts.
© 2005 LOUD Technologies Inc. All Rights Reserved.
Part No. 0016401 Rev. A 09/05
�
�
�
�
�
�
�
����� �����
��������� �����
�������� �����
�
�
�
����
� � �������� ������
��� ���
� � ������ ������
������ ���� ���� �����
����� ������� ���������
����� �������� �����
LOUD Technologies Inc. • 16220 Wood-Red Road NE
Woodinville • WA • 98072 • 800/258-6883
Outside the U.S. call 425/487-4333 • FAX 425/487-4337
�
�
���� ������
�� �
� � �� �
� �
� � � �
� �
� � � �
� �� �
� �� �
� �� �
� �� �
���� �������� �������
�� ������ �� �������
�
�
�
�