Table of Contents
Advertisement
2 Material damage
avoid
Follow this instruction to avoid
material damage and damage to the
device.
PAY ATTENTION!
Incorrect dosage of fabric softeners,
detergents, care products and
cleaning agents can affect the
functioning of the appliance.
Follow the manufacturer's
▶
dosing recommendations.
Exceeding the maximum load
quantity affects the operation of the
appliance.
Observe and do not exceed the
▶
maximum load for each
programme.
→ "Programs", Page 26
The device is secured for transport
with transport locks. Transport locks
that have not been removed can lead
to material damage and damage to
the device.
Before commissioning, remove
▶
and store all transport locks
completely.
Before each transport, install all
▶
transport locks completely to avoid
transport damage.
Improper connection of the water
inlet hose can lead to material
damage.
Tighten the screw connections on
▶
the water supply hand-tight.
It is best to connect the water
▶
inlet hose directly to the water tap
without additional connecting
elements such as adapter,
extension, valve or the like.
Make sure that the internal
▶
diameter of the water tap is at
least 17 mm.
Avoid material damage NL
Make sure that the thread length
▶
on the connection to the water
tap is at least 10 mm.
Water pressure that is too low or too high can
interfere with the appliance function.
Make sure that the water
▶
pressure on the water supply
system is at least 100 kPa (1 bar)
and at most 1000 kPa (10 bar).
If the water pressure exceeds the
▶
specified maximum value, a
pressure reducing valve must be
installed between the drinking
water connection and the hose
set of the device.
▶
Do not connect the appliance to the
mixer tap of a pressureless water
heater or boiler.
Modified or damaged water hoses
can lead to material damage and
damage to the device.
Never kink, pinch, modify or cut
▶
water hoses.
Only use supplied water hoses or
▶
original spare hoses.
Reuse never used water hoses.
▶
Use with contaminated or too hot
water can cause material damage
and damage to the device.
Operate the device only with cold
▶
tap water.
Unsuitable cleaning agents can
damage the surfaces of the device.
Do not use sharp or abrasive
▶
cleaning agents.
Do not use strong alcohol-based
▶
cleaning agents.
▶ Do not use hard scouring or
dishwashing sponges.
Clean the device only with water
▶
and a soft, damp cloth.
11
Advertisement
Table of Contents
