Advertisement
• Plug the mains lead into a 13 Amp mains socket.
• If connecting via an extension lead, make sure that the lead is rated at 3 Amps or more, and that it is
fully unwound. If any other appliances are connected to the same extension lead, make sure that it is
rated for the total power of all appliances connected.
• Switch the appliance on at the mains socket.
• Use the rotary switch to select the speed required:
O = OFF
1 = low speed
2 = medium speed
3 = high speed
• It is normal for the motor to become warm when in use.
• Unplug the appliance from the mains supply when not in use.
At time of going to press, the average cost of electricity is £0.14 per unit (kilowatt-hour). The amount you
are being charged will be shown on your electricity bill. At this cost, the EH1812 will cost 13p per day to
run on the "low speed" setting, or 20p per day to run on the "high speed" setting. the EH1814 will cost
21p per day to run on the "low speed" setting, or 33p per day to run on the "high speed" setting.
When used in an office environment, this product must be safety-tested yearly by a qualified electrician
(PAT Tested) in order to comply with the Electricity at Work Regulations.
We recommend that it is PAT tested regularly when used in a domestic environment.
Domestic wiring must be tested periodically by a qualified electrician at least once every 10 years or at
every change of occupancy.
For office and retail premises, and buildings such as village halls, the wiring must be inspected at least
once every 5 years.
It is recommended that all building be fitted with smoke alarms (it is mandatory for new buildings).
You must not dispose of this appliance with domestic household waste.
Most local authorities have specific collection system for appliances and disposal is free of charge to the
end-user.
When replacing an existing appliance with a similar new appliance your retailer may take the old
appliance for disposal.
Before cleaning, turn the appliance off, and disconnect from the mains supply. The appliance may then
be cleaned using a damp cloth with a drop of washing-up liquid to remove any dust or dirt from the case.
Do no use stronger detergents or solvents as these may damage the paint finish.
Using a dry 1" (25 mm) paint-brush, remove any dust from the grilles.
If the mains lead is damaged, it must be replaced by the manufacturer or and authorised service centre.
MAINTENANCE CONTINUES ON NEXT PAGE
OPERATION
OPERATING COSTS
PAT TESTING
GENERAL SAFETY REQUIREMENTS
DISPOSAL AND RECYCLING
MAINTENANCE
Advertisement
