Reset To Factory Defaults - Honeywell CIPer 30 Installation And Operation Manual

5. Configure Serial port setup and Enter the login credentials for platform
6. Click OK to Save the changes.

Reset to factory defaults

In case you forget the station credentials, you can reset to the factory defaults. Follow the below steps
to reset CIPer 30 controller to default factory setting. Since this operation is performed in bootloader,
the controller must be running in bootloader.
1. Connect the CIPer 30 controller with serial console using terminal emulators tool (for example
Putty).
Note:
The default baud rate of the CIPer
CIPer MODEL 30 CONTROLLER - INSTALLATION AND OPERATIONS GUIDE
TM
controller is 115200bps.
Model 30
37 31-00206 - 02