Haier HW80-B16939S8 User Manual page 73

3.4 Detergent drawer
Open dispenser drawer, the following components can
be seen (Fig. 3-5):
1: compartment for powder or liquid detergent.
2: detergent flap slector, lift it up for powder detergent,
keep it down for liquid detergent.
3: compartment for softner.
4: lock tab, press it down to pull out dispenser drawer.
The recommendation on the type of the detergents
is suitable for the various washing temperatures.
Please refer to the manual of detergent(see P11).
3.5 Function buttons
T h e u f n t c o i n b t u o t
tions in the selected programme before the program-
me starts. The related indicators are displayed.
By switching off the appliance or setting up a new pro-
gramme, all options are disabled.
If a button has multiple options, the desired option can
be selected by pressing the button sequentially.
By pressing the buttons, when it is in bright light, the
function is selected.
Note: Factory settings
To get the best results in each programme, Haier has well defined specific default
settings. If there is no special requirement, default settings are recommended.
3.5.1-Function button " Delay"
Press h t s i b t u o t n F (
with a delay. End time delay could be increased in steps
an original programme time).
6:30 means end of programme
and 30 minutes. Press "Start/Pause" button to activate
the time delay. It is not applicable to programme Spin,
Refresh.
Note: Liquid detergent
If using liquid detergent, it is not recommended to activate the end time delay.
3.5.2 Function button "Anti-crease"
For those programmes that can select "Anti-crease" function (Fig. 3-8) , press "Anti-crease"
button to select this function and the corresponding icon will light up. Press again or select
another programme, this feature will be cancelled.
Under "Anti-crease" function, the max spin speed will be set to 800 rpm.
After spin, the washing machine keeps intermittent operation to shake off the clothes to
prevent mildew and odor, reduce wrinkles and make them smoother after hanging up.
During operation, the LED display will show " - " " -- " " --- " " ---- ", and this phase lasts for
12 hours at most, users can press "Start/Pause" to terminate the programme at any time.
s n F ( . g i - 3 ) 6 e n b a e l
. g i - 3 ) 7 o t s a t t r h t
(End time will longer th-
cycle will be in 6 hours
d a d t i o i a n o l p
-
amme
e p o r r g
4
2
1
3
3.5.1 3.5.3 3.5.5
Anti-crease
3.5.2 3.5.4
3-7
Anti-crease
3-5
3-6
3-8
9