Backup Controller Function; Backup Controller With Trigger Button; Load Data With Epson Rc+ 7.0; Transfer With E-Mail - Epson RC700 Series Original Instructions Manual

Functions 8. Memory Port

8.3 Backup Controller Function

8.3.1 Backup Controller with Trigger Button


Controller status storage function is available at any time and in any Controller
status after starting the Controller.
However, operations form the console including stop and pause are not available
when executing this function.
CAUTION
Also, this function influences the robot cycle time and the communication with the
EPSON RC+ 7.0. Do not execute this function while operating the robot except
when it is necessary.
Use the following procedure to backup the Controller settings to USB memory.
(1) Insert the USB memory into the memory port.
(2) Wait approximately 10 seconds for USB memory recognition.
(3) Press the trigger button on the Controller.
(4) The seven-segment displays
(5) When the storage has been completed,
(6) Remove the USB memory from the Controller.
NOTE
 -
-

8.3.2 Load Data with EPSON RC+ 7.0

The procedure to read the data stored in the USB memory by EPSON RC+ 7.0 and display
the Controller status is described in the following manual.
EPSON RC+ 7.0 User's Guide 5.11.8 [Controller] Command (Tools Menu)

8.3.3 Transfer with E-mail

Follow this procedure to transfer the data by e-mail that was saved to the USB memory.
(1) Insert the USB memory to a PC that supports sending of e-mail.
(2) Make sure that the USB memory has following folders.
(3) Compress the folders checked in Step (2), then send them by e-mail.
- Delete files that do not relate to the project before transfer.
NOTE

- This function is used to send the data to the system director and EPSON from the end
users for problem analysis.
124
transfer. Wait until the display returns back to the former display. (Transfer time
differs depending on the amount of data, such as the project size.)
two seconds.
When the storage has failed,
seconds.
USB memory with LED is recommended to check the status changes in procedure (2).
When storage is executed during Motor ON status, it may fail to store the status. Use
another USB memory or execute the storage during Motor OFF status.
BU_Controller type_serial number_backup date
→ Example: BU_RC700_12345_2013-10-29-092951
and repeatedly during the data
is displayed on the seven-segment for
is displayed on the seven-segment for two
RC700 Series Rev.3