Table of Contents
Advertisement
3
.
I
n
s
t
a
l
l
a
3
.
I
n
s
t
a
l
l
a
This section will guide you to install the AP through hardware / wall-mounting
connection.
For hardware connection, refer to the following steps to connect your devices
correctly.
1.
Connect VigorAP 906 to xDSL modem, router, or switch/hub in your network
through the LAN B port of the access point by Ethernet cable.
You can also connect VigorAP 906 to a Vigor router via wireless connection.
For detailed information, refer to VigorAP 906 User's Guide.
2.
Connect a computer to other available LAN A port. Make sure the subnet IP
address of the PC is the same as VigorAP 906 management IP, e.g.,
192.168.1.X.
3.
Connect the A/C power adapter to the wall socket, and then connect it to
the PWR connector of the access point.
4.
Power on VigorAP 906.
5.
Check all LEDs on the front and back panel. The ACT LED on the front panel
should blink; WAN/LAN LED on the back panel should be on if the access
point is correctly connected to the xDSL modem, router or switch/hub.
t
i
o
n
t
i
o
n
4
Advertisement
Table of Contents
