Troubleshooting - Black Max BM25CSEDG Operator's Manual

Table of Contents

Advertisement

Available languages

Available languages

THIS PRODUCT WAS MANUFACTURED WITH A CATALYST MUFFLER
Congratulations! You have made an investment toward protecting the environment. In order to maintain this product's
original emission level, please refer to the maintenance section below.
Maintenance
Part
* CATALYTIC MUFFLER ASSEMBLY..................................................................................................................X
SPARK SCREEN ...............................................................................................................................................X
* AIR FILTER ASSY
includes:
Filter Screen ........................................................................ X
* CARBURETOR ASSY
includes:
Gaskets ........................................ X
* FUEL TANK ASSY
includes:
Fuel Lines ..................................... X
Fuel Cap ....................................... X
Fuel Filter................................................................................................................... X
* IGNITION ASSY
includes:
Spark Plug ................................................................................................................. X
* NOTICE: THE USE OF EMISSION CONTROL COMPONENTS OTHER THAN THOSE DESIGNED FOR THIS UNIT
IS A VIOLATION OF FEDERAL LAW.
PROBLEM
Engine will not start
MAINTENANCE
MAINTENANCE SCHEDULE
Inspect For
Damage Before
Each Use

TROUBLESHOOTING

POSSIBLE CAUSE
No spark
No fuel
Engine is flooded
Page 13 — English
Clean
Replace
Every
Every 25 Hours
5 Hours
or Yearly
Clean or replace spark plug. Reset spark plug gap.
Refer to Spark Plug Replacement earlier in this
manual.
Push primer bulb until bulb is full of fuel. If bulb does
not fill, primary fuel delivery system is blocked. Contact
a qualified service dealer. If primer bulb fills, engine
may be flooded, proceed to next item.
Set the choke lever to the FULL CHOKE position.
Squeeze the trigger and pull the starter grip and rope
repeatedly until the engine starts and runs.
NOTE: Depending on the severity of the flooding, this
may require numerous pulls of the rope.
Replace
Every
50 Hours
SOLUTION

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents