Table of Contents
Advertisement
If there is no valid operation within 20 seconds, it will automatically return to normal time mode from the set
mode.
Setting the daily alarms:
Press once
button, LCD will display
to represent Alarm1ON (Alarm2 OFF), Alarm2 ON (Alarm1 OFF), Alarm1&Alarm2 ON. Press
again to Alarm1 and Alarm2 all OFF (no"
Press once "
ALARME
ALARME
alarm2 time, press "
ALARME button for 3 seconds,
Press and hold
and "-" buttons to set the required hour.
ALARME
Press
button to confirm your setting, the Minute of the Alarm1 time starts to flash. Use the "+" and
"-" buttons to set the required minute.
ALARME
Press
button to confirm your setting, the hour of the Alarm2 time starts to flash. Use the "+" and
"-" buttons to set the required hour.
Press
ALARME
button to confirm your setting, the minute of the Alarm2 time starts to flash. Use the "+" and
"-" buttons to set the required hour.
Press
ALARME
button to confirm your setting and to end the setting procedure.
F.Y.I.:
If there is no valid operation within 20 seconds, it will automatically return to normal time mode from the
alarm time set mode.
The alarm will sound for 2 minutes if you do not deactivate it by pressing any button. In this case the alarm
will be repeated automatically after 24 hours.
Rising alarm sound (crescendo) changes the volume 4 times whilst the alarm signal is heard.
Switching off the alarm signal
When the alarm is ringing, press any button except the "
not necessary to reactivate the alarm. It will ring again this time next day.
Snooze function
When the alarm is ringing, press the "
alarm signal sounds again after 8 minutes.
RF Transmission Procedure
The weather station automatically starts receiving transmission from outdoor remote sensor for outdoor
temperature & humidity after batteries inserted.
The remote sensor will automatically transmit temperature and humidity data to the Weather Station after
batteries inserted.
If the Weather Station failed to receive transmission from outdoor remote sensor ("- -.-"display on the LCD),
Press the CH button to select the channel, the number of selected channels will flash, then press and hold
EM3383D_DCF User Manuals
"and" "
" button, LCD display alarm1 time, press "
return to time display.
" button again,
LUM / SNZ
, press again to display
display).
until the hour of the Alarm1 time starts to flash. Use the "+"
LUM / SNZ
" button the alarm mode will to get to snooze mode. The
, press again to display
ALARME
" button again, LCD display
" button to stop the alarm signal. It is
, each
button
Advertisement
Table of Contents
