Table of Contents
Advertisement
Installation and connection
en
Before using the appliance for the first time
Remove information material, adhesive tape and
1.
protective film.
Clean the appliance.
2.
~ "Cleaning" on page 19
Water connection
Caution!
Installation and connection of the appliance must be
■
carried out by qualified technicians according to the
installation instructions supplied.
To avoid damage to the appliance and to ensure its
■
proper functioning, it should only be connected to a
drinking water system.
To avoid water damage, a shut-off valve must be
■
installed.
Water pressure of drinking water system
Caution!
If the water pressure exceeds the maximum value, a
pressure relief valve must be installed between the
drinking water connection and the hose set to avoid
damage to the appliance.
Note: If the water pressure is too low, this will impair the
appliance functions.
Min. 0.2 Mpa (2 bar/29 psi)
■
Max. 0.8 Mpa (8 bar/116 psi)
■
8
Electrical connection
Caution!
Do not connect the appliance to electronic energy saver
plugs.
Note: You can connect the appliance to mains-
controlled and sine-controlled inverters.
Mains-controlled inverters are used for photovoltaic
systems which are directly connected to the national
grid. Sine-controlled inverters must be used for isolated
applications.Isolated applications, e.g. on ships or in
mountain lodges, which are not directly connected to
the national grid.
After installing the appliance, wait at least 1 hour
1.
before connecting it to avoid damaging the
compressor.
Connect the appliance to a correctly installed
2.
socket.
The socket must comply with the following data:
Socket with
Protective conductor 50 Hz
Fuse
Outside Europe: Check whether the indicated
current type of the appliance corresponds with the
values of your power supply. The appliance
specifications are specified on the rating plate.
~ "Getting to know your appliance" on page 9
Connect the appliance to a socket near the
3.
appliance.
The socket must also be freely accessible after
installation of the appliance.
:
Warning
Risk of electric shock!
If the length of the mains cable is insufficient, do
NOT use multi-outlet power strips or extension
leads.Instead, please contact Customer Service for
alternative solutions.
220 V ... 240 V
10 A ... 16 A
Advertisement
Table of Contents
