Table of Contents
Advertisement
Gas burners
en
It is essential to ensure that all the burner parts and pan
supports are correctly installed for the appliance to
work correctly. Do not swap the burner caps around.
Always remove the pan supports carefully. When
moving a pan support, the pan supports next to it may
also move.
Burner parts
1
Ignition plug
2
Thermocouple
3
Burner cup
4
Burner cap
Accessories
Depending on the model, the hob may include the
following accessories. These can also be acquired from
the Technical Assistance Service.
10
Additional wok grid
Only suitable for use on wok
burners. Use cookware with a
rounded base.
To extend the service life of the
appliance, we recommend using
the additional wok grid.
Additional espresso maker
grid
Only suitable for use on the
smallest burner. Use cookware
with a diameter of less than
12 cm.
--------
Code
HZ233540 Additional wok grid: Cast iron (4-5 kW)
HZ233440 Additional wok grid: Cast iron (mini wok
burner)
HZ241110 Additional espresso maker grid
HZ298105 Simmer Plate
HZ211310 Simmer cap
The manufacturer accepts no liability if these
accessories are not used or are used incorrectly.
ÄGas burners
S witching on manually
G a s b u r n e r s
Press the control knob for the selected burner and
1.
turn it anticlockwise to the highest power setting.
Hold an igniter or a naked flame (such as a lighter or
2.
a match) against the burner.
Automatic ignition
If the hob has automatic ignition (ignition plugs):
Press the control knob for the selected burner and
1.
turn it anticlockwise to the highest power level.
While the control knob is held down, all the burners
will generate sparks. The flame ignites. Wait a few
seconds.
Release the control knob.
2.
Turn the control knob to the required position.
3.
If the burner does not ignite, switch it off and repeat the
steps described above. This time, hold the control knob
down for longer (up to 10 seconds).
Simmer plate
This accessory part is only suita-
ble for simmering. It can be
used with the economy burner
or the standard-output burner. If
your hob has several standard-
output burners, we recommend
placing the simmer plate on the
rear or front-right standard-out-
put burner.
Place the accessory component
with the projections facing
upwards on the holder; never
place it directly on the burner.
Simmer cap
Only use the cap for cooking
with minimal power. Place the
simmer cap on the cover of the
economy burner. Always place
cookware on the pan support,
never directly on the simmer
cap.
Advertisement
Table of Contents
