Trolling Motor Bracket Installation - Lowrance Skimmer Transducer Installation Instructions Manual

Manual locking collar connector
requires a 1" hole.
Caution:
If you drill a hole in the transom for the cable, make sure it is lo-
cated above the waterline. After installation, be sure to seal the
hole with the same marine grade above- or below-waterline seal-
ant/adhesive used for the mounting screws.
7. Make a test run to determine the results. If the bottom is lost at
high speed, or if noise appears on the display, try sliding the trans-
ducer bracket down. This puts the transducer deeper into the water,
hopefully below the turbulence causing the noise. Don't allow the
transducer bracket to go below the bottom of the hull!

TROLLING MOTOR BRACKET INSTALLATION

(single-frequency only)
1. Attach the TMB-S bracket to the transducer as shown in the follow-
ing figure, using the hardware supplied with the transducer. (Note:
The internal tooth washer is supplied with the TMB-S.)
Bolt
Attach motor mounting bracket to transducer.
2. Slide the adjustable strap supplied with the TMB-S through the slot
in the transducer bracket and wrap it around the trolling motor. Po-
sition the transducer to aim straight down when the motor is in the
water. Tighten the strap securely.
3. Route the transducer cable alongside the trolling motor shaft. Use
plastic ties (not included) to attach the transducer cable to the troll-
Internal tooth washer
Nut
Flat washer
11
Push-on self-sealing connector
requires a 5/8" hole.
TMB-S bracket