Table of Contents
Advertisement
Bolt
Washer
Portable transducer assembly: rear view (left) and side view (right.)
Clean the chosen area of the hull before attaching the suction cup. Lo-
cate the transducer on the hull as shown in the following figure. Don't
let the bracket extend below the hull, because water pressure against it
can cause the suction cup to come off at speed.
NOTE:
For optimum operation, the portable transducer should be adjusted
so that it is parallel to the ground. For more information on this,
see the segment in the unit's operation manual on Transducer Ori-
entation and Fish Arches.
Moisten the suction cup, then press it onto the hull as firmly as possi-
ble. Tie the nylon cord to the boat and set the power pack and sonar unit in
a location for easy viewing. Your portable sonar is now ready for use.
Portable transducer installed on boat transom.
Tie
nylon
cord
here
Suction
Nut
Washer
Transducer
Hull
cup
9
Screw
Advertisement
Table of Contents
