Summary of Contents for Lorex QDR-TELS
- Page 1 Power Up your Computer Remotely QDR-TELS QDR-TELS USER GUIDE USER GUIDE ( Version 1.0 ) ( Version 1.0 QDR-TELS © 2003 Strategic Vista Corp.
- Page 2 1. QDR-TELS Introduction The QDR-TELS module is an accessory to the VISTAPRO 4 which allows you to power up/power down your computer remotely via the telephone. Note that you must also be using the I/O Alarm block with your VISTAPRO 4 in order to incorporate the QDR-TELS.
- Page 3 Step 3: Power Up the Module To apply power to the module, plug the power connector from the supplied Power Supply Adapter into the Power Jack (located on the back of the QDR-TELS module). Plug the Power Cord into a 110/120 VAC outlet..
- Page 4 3. Connection Diagram & Installation QDR-TELS QDR-TELS FRONT BACK TELEPHONE POWER RESET Port DC 9V/12V Ribbon Cable Connector POWER from PC POWER from PC to Connect VistaPro 4 with Power Supply Power Supply I/O Alarm Block POWER PIN from POWER PIN from...
- Page 5 NOTES: In order for the QDR-TELS to operate properly, the VistaPro 4 and I/O Alarm Board must already be installed in the PC with particular attention to the items below: 1. The VistaPro 4 main board and I/O board have to be connected each other.(I/O board cable connector) 2.
- Page 6 After the designated number of rings, the module will pick up and request a PIN. If a valid PIN is entered, the QDR-TELS module will prompt to the user the current status of the computer, (On or Off). At this time, the user is presented with the following options.