Unit Status Monitoring And The Detected Value Indication - Fujitsu General ARXG45KHTB Service Manual

6-13. Unit status monitoring and the detected value indication

The wired remote controller can monitor the indoor and outdoor units' status and display the detect-
ed result as a relevant ID.
For details of the display method, refer to the Chapter of "Display Sensor Values" in the Installation
Manual of Wired remote controller (Touch panel).
The status can be monitored and displayed on the wired remote controller by assigning an arbitrary
ID. For available ID list, refer to the table below.
NOTE: Operating time for each part cannot be reset when the part is replaced. Take notes of the
operating time before replacing to count the operating time of the replaced part.
Sensor ID
00: Indoor unit
00 000 Suction temp.
00 001 Room temp.
Wired remote controller detected
00 002
temp.
Wireless remote controller detected
00 003
temp.
00 004 Discharge air temp.
00 005 Heat exchanger inlet temp.
00 006 Heat exchanger middle temp.
00 007 Heat exchanger outlet temp.
00 020 Fan rotation number
00 021 Fan 2 rotation number
00 022 Fan 3 rotation number
00 030 Expansion valve
00 040 Operating pulse for right filter
00 041 Operating pulse for left filter
00 042 Operating pulse for filter brush
00 050 Power relay for outdoor unit On/Off
00 051 Float switch On/Off
00 052 Drain pump On/Off
Solenoid valve for reheat operation
00 053
On/Off
00 054 Air cleaner status On/Off
00 055 Limit switch 1 (For grille) On/Off
00 056 Limit switch 2 (For right filter) On/Off
00 057 Limit switch 3 (For left filter) On/Off
00 070 Current sensor
00 080 Indoor unit total energized hours
00 081 Total filtering hours
00 082 Indoor unit fan total operation hours
00 083 Indoor unit fan 2 total operation hours
00 084 Indoor unit fan 3 total operation hours
00 090 Temperature sensor
Presence or absence detected by
00 095
human sensor
6-13. Unit status monitoring and the detected value indication
Available Sensor ID
Item
01: °C or °F
01: °C or °F
01: °C or °F
01: °C or °F
01: °C or °F
01: °C or °F
01: °C or °F
01: °C or °F
- (04-24) -
Unit
When the wired remote controller
thermistor is enabled, temperature of
the wired remote controller thermistor
is displayed.
Temperature detected by wireless
remote controller
03: rpm
03: rpm
03: rpm
05: pls
05: pls
05: pls
05: pls
08: On/Off 0: Off, 1: On
0: Off, 1: On (When the water level
08: On/Off
rises)
08: On/Off 0: Off, 1: On
08: On/Off 0: Off (Opened), 1: On (Closed)
08: On/Off 0: Off, 1: On
08: On/Off 0: Off, 1: On
08: On/Off 0: Off, 1: On
08: On/Off 0: Off, 1: On
09: A
11: h
11: h
11: h
11: h
11: h
12: %
0: Absence, 1: Presence
00: — —: Human sensor error or No human
sensor
Remarks
6. Various control