Advertisement
STEP 2
SETTING UP YOUR DIGTIAL VIDEO RECORDER (DVR)
Carefully follow the steps to ensure correct installation of the DVR HDD. Note: Please set the HDD to "MASTER OR SLAVE MODE(S)"
INDICATES WHERE THE SCREWS ARE PLACED
Open the upper cover of the DVR
Loosen the two screens respectively on the two sides of the
upper cover. Loosen the four screws on the back side of
the upper cover.
SCREWS
BACK OF THE DVR
HDD BRACKET
SCREWS
4
Screw the
HDD bracket
back to the
DVR base
HDD BRACKET
SCREWS
NOTE: Please make sure to place the HDD connector facing the back panel of the DVR
L224 Series QSG-EN_R2 Page 2
2
Unscrew the HDD bracket
SIDE OF THE DVR
HDD BRACKET
SCREWS
INSIDE OF THE DVR
5
Connect the HDD to the power connector and IDE Bus (make
sure to align the HDD precisely for PIN connection).
INSIDE OF THE DVR
- HARD DISK DRIVE (HDD) INSTALLATION
INSIDE OF THE DVR
IDE BUS
INSIDE OF THE DVR
BUS IN ESS & HOM E SECURI TY
3
Screw the HDD onto the HDD bracket
SCREWS
HDD BRACKET
6
Close the upper case of the DVR and fasten all the
screws you loosened in the Section .
SCREWS
HDD POWER
CONNECTOR
BACK OF THE DVR
www.lorexcctv.com
HDD
SIDE OF THE DVR
DVR CASE
Advertisement
