Advertisement
When using your electrical appliance, basic precautions should always be followed, including the following:
READ ALL INSTRUCTIONS AND SAFEGUARDS BEFORE USING THIS SHAVER.
To reduce the risk of death or injury by electric shock:
To reduce the risk of burns, fire, electric shock or injury to persons:
SAVE THESE INSTRUCTIONS
For Household Use Only
DISPOSAL OF NI-CAD BATTERY CONTAINS SEALED, RECHARGEABLE NICKEL-CADMIUM BATTERY. MUST BE RECYCLED OR DISPOSED OF PROPERLY.
Depending on use, your battery should last four to six years before replacement is necessary. When replacement is necessary, follow these simple steps:
CONGRATULATIONS! You own the Wahl® DynaFlex® Shaver. It has a patented high-speed cutting system and specially angled Flex-Foil™ dual heads. . . for remarkably close, amazingly fast shaves! Plus, a concealed full-width trimmer located on the back of the shaver pops up and away from the foil head for clear view shaping of sideburns, beards and mustaches. We at Wahl are confident you will find extraordinary shaving speed, comfort and closeness. Just follow the tips in this folder.
If you are using an electric shaver for the first time, your skin will probably need to condition itself to this new shaving technique. Start on the easiest part of the face first, usually the smooth portion of the face below the ear. Shave with a light touch and use your Wahl Shaver exclusively for three to four weeks, or longer if you have sensitive skin or if your whiskers grow at different angles in certain areas. Initially your shaves may not be as close as you would like, and your skin may become a bit irritated. But if you stick with it, you will eventually get great shaves.
If you go several days without shaving and your beard gets a bit long, use the pop-up trimmer to go over your beard, catching all the longer hairs and setting up the remaining stubble for the foil to shave smooth and clean.
If you have been using another type of electric shaver before, there may also be a period of conditioning prior to receiving maximum results.
The Wahl® Bump-Free Shaver uses a very powerful rotary motor that delivers 10,000 cycles per minute to the cutter head. This results in a very strong audible hum, but is completely normal to its operation.
Don't settle for a weak shaver!
Do Not Rinse Shaver
Many African-American men suffer from pseudofolliculitis barbae also known as razor bumps. There are few solutions to this problem, but the Wahl® Bump-Free shaver can help by:
Because this foil is capable of shaving very close, use only a light touch when shaving the neck and other areas where the skin may be thin and sensitive.
Replacement Foil & Cutter Bar: #07019-500
We suggest that you thoroughly cleanse and completely dry your skin prior to shaving. For maximum speed and efficiency, hold the shaver so that both screens are in contact with the skin. When shaving the upper lip or neck, hold shaver so that the uppermost screen is in contact with skin.
Shave both with and against the grain of the beard, and stretch the skin taut in the path of the shaver. Guide the dual foil heads gently back and forth, primarily against the grain of the beard. Do not press screen heads hard against face. Heavy scrubbing action with the shaver could damage the foil and will not result in a closer shave. As a general rule, we recommend replacing the Flex Foil Head every six months for maximum results. The foil is micro-thin with precise, raised inner cutting edges around the whisker holes. These raised cutting edges will wear with use, which will be indicated if your shaver slows down and the blades seem to get warm. Always replace the Foil Guard to protect the delicate dual foil heads when shaver is off. To ensure continued shaving satisfaction, you should replace the foils and cutter bar periodically.
Begin shaving in a less dense area of the beard. Move the shaver in a circular motion on a small area of the face (this picks up the hairs that grow in all directions). When you see that this small area is shaved clean, gradually move into a new area while still using the circular motion. Continue this motion, one small section at a time, until entire face is shaved.
If your beard has more than 24-36 hours of growth, use the pop-up Long-Hair Trimmer to cut the beard down to about a one-day growth before using the shaver foil.
Your shaver features a special Long-Hair Trimmer located on the back of the shaver which telescopes up and away from the Flex Foil Head for precise and easy trimming of sideburns, beards or mustaches, and for removing long hairs from the neck. And, as mentioned earlier, it can be used to "knock down" heavy beard growth prior to shaving with the foil.
To use, remove Foil Guard and simply push the Long-Hair Trimmer Switch in an upward motion until trimmer slides (clicks) into position. Push On/Off Switch to "ON" position (marked "l" on shaver). Then begin trimming/styling.
of Patented DynaFlex Cutters (EPO. Pat. No. 486.903) and Flex Foil Heads
For maximum performance, we recommend you clean your shaver after every few shaves. Any servicing, other than replacement of Flex Foil Head and Cutter Bar Assembly, should be performed by an authorized Wahl Shaver Service Center or Wahl Clipper Corporation (see Warranty for mailing address information).
To clean, turn shaver "OFF" and remove the Flex Foil Head by pushing the Shaver Head Release Button on the side of the shaver and lifting the foil head upward.
Lightly tap the open side of the Flex Foil Head on a hard surface to remove the majority of loose stubble particles. Be careful not to tap foil.
Turn shaver off. Remove the foil head and, holding the shaver in one hand, gently press down on the cutter bar to rotate it 90° (1/4 turn) and gently lift it upward. Be sure your thumb and first finger are positioned at each end of the Cutter Bar Assembly. Use the cleaning brush provided to remove whiskers between the cutting blades. Brush carefully, so as not to break the cutter bars apart. NOTE: If you do not hold the Cutter Bar Assembly as shown, brushing the blades could result in damage to the assembly.
When the Flex Foil Head and Cutter Bar Assembly are removed from the shaver, an alternate cleaning method is to rinse them under running water. Simply let them air dry.
After cleaning, replace the Cutter Bar Assembly by pressing it down gently and rotating 90° (1/4 turn) to lock into place. Carefully replace the Flex Foil Head, snapping it into place.
From time to time, depending on the density of your beard, you will need to replace the cutters and foils. If you notice that it is taking you longer to shave, or if your face starts to feel some irritation, or if the foil seems to become warm to the touch, it is probably time to replace the cutters and foils. Replace the cutters and foils only with WAHL parts.
If you have problems with your trimmer, send it prepaid with a note explaining the problem to:
Wahl Clipper Corporation
Attn: Repair Department
3001 Locust Street
Sterling, IL 61081
Telephone (800) 767-9245
For products purchased outside the United States, contact your distributor.
60 Day Money Back Guarantee!
If for any reason within 60 days of purchase of your Wahl® trimmer you are not satisfied with your trimmer and would like a refund, just return your trimmer, together with the sales receipt, to the retailer from whom you purchased it. Wahl will reimburse all retailers who accept trimmers within 60 days of purchase. If you have any questions regarding this moneyback guarantee, please call 1-800-767-9245 in the United States.
3-YEAR LIMITED WARRANTYValid in U.S.A. Only If your Wahl product fails to operate satisfactorily within three (3) years from the date of original purchase or receipt as a gift, Wahl will, at our option, repair or replace it and return it to you FREE OF CHARGE. Do not return this product to store where purchased. Products needing repair under this warranty should be returned with postage prepaid to: Include a note describing the defect and the date of original purchase or receipt as a gift (if in warranty). Products out of warranty will be repaired at our standard repair charges. This warranty is void and no repair or replacement will be made under this warranty or otherwise if:
This warranty gives you specific legal rights and you may also have other rights which may vary from state to state. No other written express warranty is given. Any implied warranty, including any warranty of merchantability which may arise from purchase or use, is limited to the year period provided in this express warranty. Some states may not allow such limitation, so it may not apply to you. No responsibility is assumed for incidental or consequential damages of any type, or for the use of unauthorized attachments. Some states may not allow the exclusion or limitation of incidental or consequential damages, so the limitation or exclusion may not apply to you. Outside U.S.A., check with store for Wahl authorized distributor's warranty. |
For more information or Product Registration, visit shavers.wahl.com
© 2014 Wahl Clipper Corporation
Part No. 95809
Printed in U.S.A.
Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.
Download Wahl Bump-Free - Rechargeable Shaving System Manual
Advertisement
Thank you! Your question has been received!
Need Assistance?
Do you have a question about the Bump-Free that isn't answered in the manual? Leave your question here.