Table of Contents
Advertisement
DIR-841 AC1200 Wave 2 MU-MIMO Wi-Fi Router
with Gigabit WAN Port
User Manual
Parameter
Enable shaping
Broadcast wireless
network
Clients isolation
Enable guest network
In the Security Settings section, you can change security settings of the wireless network.
By default, the WPA2-PSK network authentication type of both bands of the wireless network is
specified. WPS PIN from the barcode label is used as the network key.
Figure 90. Network authentication types supported by the router.
The router supports the following authentication types:
Authentication type
Open
WEP
Move the switch to the right to limit the maximum bandwidth of the
wireless network. In the Shaping field displayed, specify the
maximum value of speed (Mbps).
Move the switch to the left not to limit the maximum bandwidth.
If the switch is moved to the left, devices cannot connect to the
wireless network. Upon that the router can connect to another access
point as a wireless client.
Move the switch to the right to forbid wireless clients of this
wireless network to communicate to each other.
This function is available for the additional network. Move the
switch to the right if you want the devices connected to the
additional network to be isolated from the devices and resources of
the router's LAN.
Open authentication (with WEP encryption for wireless network
modes not supporting 802.11n or 802.11ac devices).
Authentication with a shared key with WEP encryption. This
authentication type is not available when a mode supporting
802.11n or 802.11ac devices is selected from the Wireless mode
drop-down list on the Wi-Fi / Basic Settings page.
Page 111 of 209
Configuring via Web-based Interface
Description
Description
Advertisement
Table of Contents
