Care; Troubleshooting - Electrolux ECH-1000 M EEC User Manual

convector so that it fits snugly against the
convector body.
3. Secure the chassis using the supplied
mount (Fig. 5).
4. Repeat the same procedure for attaching
the second chassis.
Figure. 4

Care

The convector does not require any special
maintenance. Before servicing (leaving) the

Troubleshooting

Malfunction
symptom
No heating
Smell of burnt dust
when first turned on
If after trying all the troubleshooting steps, the problem is not resolved, contact an authorized service cen-
ter in your area or your sales representative.
Figure. 5
Cause of malfunction
1) There is no power supply.
2) The convector is in standby mode.
3) The actual room temperature is higher
than the thermostat setting.
Not a malfunction
convector must be disconnected from the
power supply.
The body of the device should be periodically
wiped with a soft, lint-free cloth or damp
sponge. Never use abrasive, foaming
detergents or solvents. It is quite easy to clean
the space behind a wall-mounted heater.
Press down the two latches on the back of the
heater and pull the heater forward. After it is
removed, you can wash the wall on which it
was installed.
After finishing cleaning, put the heater back in
its normal operating position.
Recommended indoor temperature and
humidity:
a) for the convector operation: from -25°С to
+ 30°С, humidity from 40% to 90%;
b) for the storage of the convector: from -20°C
to + 80°С, humidity from 40% to 90%.
Troubleshooting steps
1) Establish a reliable connection.
2) Set the convector to operating
mode.
3) Adjust the temperature mode of the
convector.
The smell disappears after a few
minutes of convector operation
7
ENGLISH