Brookstone 322811 Quick Start Manual

Mini Vacuum
Keyboard
Cleaner
CAUTION
• Do not store or use vacuum in a
moist environment.
• When not in use, unplug the unit
from the USB port.
• Do not press the Turbo button while
the vacuum motor is being switched
on. This could cause a voltage jump
beyond the USB limit (500mA)
during motor start-up.
• Turn off the vacuum before separat-
ing the top and bottom sections for
cleaning.
FCC INFORMATION
Caution: Changes or modifications
not expressly approved by the party
responsible for compliance could void
the user's authority to operate the
equipment.
This equipment has been tested and
found to comply with the limits for a
Class B Digital Device, pursuant to
Part 15 of the FCC Rules. These limits
are designed to provide reasonable
protection against harmful interference
in a residential installation. This
equipment generates, uses, and
can radiate radio frequency energy
and, if not installed and used in
accordance with the instructions, may
cause harmful interference to radio
communications. However, there is no
guarantee that interference will not
occur in a particular installation.
If this equipment does cause harmful
interference to radio or television
reception, which can be determined by
turning the equipment off and on, the
user is encouraged to try to correct
the interference by one or more of the
following measures:
• Reorient or relocate the receiving
antenna.
• Increase the distance between the
equipment and receiver.
• Connect the equipment to an outlet
on a circuit different from that
to which the receiver is connected.
• Consult the dealer or an experi-
enced radio/TV technician for help.
This equipment complies with part 15
of the FCC Rules. Operation is subject
to the following two conditions:
1. This equipment may not cause
harmful interference.
2. This equipment must accept any
interference received, including
interference that may cause
undesired operation.
LOCATION OF CONTROLS
Tube Attachment
Open Button
Turbo Button
Brush Attachment
ON/OFF Switch,
Vacuum Setting, Light
Setting
USB Connector
OPERATION
1. Connect the vacuum to a USB port
of an active (powered on) laptop,
PC, or other device.
2. Insert the appropriate attachment
(Tube or Bristle Brush) into the end
of the vacuum.
3. Slide the ON/OFF switch to the
Light setting to turn on the LED
light.
4. Slide the ON/OFF switch to the
Vacuum setting to turn on the
vacuum suction. The light remains
on during vacuuming.
5. Press the Turbo button to increase
suction power to vacuum heavier
dirt and dust.
6. To empty accumulated debris, turn
off the vacuum, press the Open
button, and pull to separate the top
and bottom sections of the vacuum.
You can use the brush attachment
to gently brush dirt from the filter.
One replacement filter is included
with your vacuum. For additional
replacement filters, contact
Brookstone Customer Support.
Find thousands more
great ideas online
322811
© Brookstone 2017
Brookstone.com | 1-800-846-3000
1 Innovation Way, Merrimack, NH 03054