TP-Link VIGI C240 Quick Start Manual

Quick Start Guide
Dome Network Camera
*Images may differ from actual products.
Package Contents
Network Camera
Quick
Start
Guide
Quick Start Guide Mounting Template
1. Loosen the screws on the side of the camera to remove
the top cover.
Remove the top cover
2. Decide how to route the cable through the ceiling/wall.
Ceiling or Wall
Route the cable through the
bottom of the camera
Installing Waterproof Cable Attachments
Install the waterproof cable attachments for the network interface when the
camera is installed outdoors.
Note: Make sure each part is securely attached and the waterproof rings are
flush to keep out water.
Fix Nut Waterproof Waterproof
Ring Jacket
Waterproof Cable
Attachments
Anchors & Screws
Knock out the cable hole on the side
and route the cable from the side
Network
O-ring
Interface
Safety First:
• Make sure your power supply matches your camera. The
camera's standard power supply is 12V DC or PoE
(802.3af/at). The power source should comply with Power
Source Class 2 ( PS2) or Limited Power Source(LPS) of IEC
62368-1.
• Make sure that the wall is strong enough to withstand 4
times the weight of the camera and mounting bracket.
• If you are uncertain or uncomfortable performing the
installation, consult a qualified electrician.
Appearance
*Some models do not have the SD slot and reset button. You can check the detailed
specifications on the product page at https://www.tp-link.com/.
3. Stick the mounting template to the desired mounting place,
and mount the camera. Pay attention to the cable direction.
Ceiling or Wall
Mounting Template
Anchor
Camera
Self-tapping Screw
4. Rotate the lens base or the dome to adjust the angle of the
lens as desired. Tighten the side screws to secure the cover.
Adjust lens angle
1. Route the network cable through the following components in order: fix
nut, waterproof ring, and then the waterproof jacket.
2. Fix the O-ring to the network interface of the camera and connect the
network cables.
3. Attach the network interface with the waterproof jacket, then twist to
lock.
4. Insert the waterproof ring into the waterproof jacket. Rotate the fix nut
to secure it to the waterproof jacket.
Done! The network interface is now waterproof.
Microphone
RJ45 Ethernet Port
(supports PoE)
Power Supply Interface
(12V DC)
Micro SD Slot*
Reset Button*
Press for 5 seconds to reset the
camera to factory settings.
IR LED
White LED
Top Cover
Side Screws
Loosen to remove the top cover.
Mount the camera
Reinstall the top cover