Special Programming - Panasonic KX-TG4771C Operating Instructions Manual

Programming

Special programming

Alarm
An alarm sounds at the set time for 3 minutes
once or daily. Alarm can be set for each handset.
Important:
R Set the date and time beforehand (page 11).
Handset
1
MMENUN#720
2
MbN: Select the desired alarm option. a
MSELECTN
Off Turns alarm off. Go to step 7.
Once An alarm sounds once at the set
time.
Daily An alarm sounds daily at the set
time. Go to step 4.
3
Enter the desired month and date. a MOKN
4
Set the desired time.
5
MAM/PMN: Select "AM" or "PM". a MOKN
6
MbN: Select the desired alarm tone. a
MSELECTN
R We recommend selecting a different ringer
tone from the one used for outside calls.
7
MSELECTN a MOFFN
R When the alarm is set,
Note:
R To stop the alarm, press MOFFN or place the
handset on the charger.
R When the handset is in use, the alarm will not
sound until the handset is in standby mode.
Night mode
Night mode allows you to select a period of time
during which the handset will not ring for outside
calls. This feature is useful for time periods when
you do not want to be disturbed, for example,
while sleeping. Night mode can be set for each
handset.
Important:
R Set the date and time beforehand (page 11).
24
TG477xC(en-en)_1214_ver021.pdf
is displayed.
24
R We recommend turning the base unit ringer off
(page 13) in addition to turning the night mode
on.
R If you have set the alarm, the alarm sounds
even if the night mode is turned on.
Turning night mode on/off
Handset
1
MMENUN#238
2
MbN: Select the desired setting. a MSAVEN
R If you select "Off", press MOFFN to exit.
3
Enter the desired hour and minute you wish to
start this feature.
4
MAM/PMN: Select "AM" or "PM". a MOKN
5
Enter the desired hour and minute you wish to
end this feature.
6
MAM/PMN: Select "AM" or "PM".
7
MSAVEN a MOFFN
R When the night mode is set,
Changing the start and end time
Handset
1
MMENUN#237
2
Continue from step 3, "Turning night mode on/
off", page 24.
Changing the handset name
Each handset can be given a customized name
("Bob", "Kitchen", etc.). This is useful when you
make intercom calls between handsets. You can
also select whether or not the handset name is
displayed in standby mode. The default setting is
"No". If you select "Yes" without entering any
handset name, "Handset 1" to "Handset 6" is
displayed.
Handset
1
MMENUN#104
2
Enter the desired name (max. 10 characters;
see the character table, page 16).
R If not required, go to step 3.
3
MSAVEN
4
MbN: Select the desired setting. a MSELECTN
2 times
5
MOFFN
2011/12/14
is displayed.
16:37:35