Transducer Placement; Fitting Assembly In The Bag - Raymarine DRAGONFLY Ice Fishing Kit Installation Instructions Manual

1. Using the parts supplied with your display and the relevant, additional fixing bolts (not supplied),
attach the display's bracket to the base using the relevant mounting holes.
Important:
Additional bolts are required to connect your display to the ice fishing kit's base. The washers and
locking nuts supplied with your display can be used with the new bolts.
2. When fitting the display to its bracket / cradle, follow the relevant mounting instructions that were
included in the documentation that accompanied your display.
3. To prevent the fixings from damaging the material bottom of the ice fishing kit bag it is
recommended that the threads on the underside of the base are covered using insulation tape
or similar.

Transducer placement

1. Place the transducer in the oval recess located on the front left of the base.
2. Coil the excess transducer cable and store in the recess in front of the display.

Fitting assembly in the bag

1. Open the bag using the zip and roll up the flap so that it is out of the way of the opening.
2. Place the assembly inside the bag with the display facing the opening.
3. Feed the bag handle material under the metal assembly handle and fasten using the hook and
loop strips.