Advertisement
Messages
Description
You should reset the printer to
Reset to Save
save the current settings.
The printer is checking the ROM.
ROM CHECK
The printer is running a self-
Self Test
diagnostic program.
The printer is turned on, but is in
Standby
the energy-saving mode.
The printer is warming up.
Warming Up
Writing ROM A
The printer is writing data onto
the ROM in slot A.
The printer is writing data onto
Writing ROM P
the program ROM module.
Error message list
Messages
Description
The printer has encountered
Can't Print
problems during duplex
Duplex
printing. Make sure you are
using an appropriate type and
size of paper for the Duplex Unit.
The problem could also be a
result of incorrect settings for the
paper source you are using.
Pressing the Continue button will
resume single-side printing.
Messages
Description
Check Duplex P-
The size of paper being printed
on is different from the specified
size
paper size during duplex
printing and printing stops. Load
the specified paper source with
the correct paper size. Then
open the cover of the Duplex
Unit and remove any jammed
paper. The jammed page's
print data is automatically
reprinted once you close the
cover of the Duplex Unit.
You have loaded media other
Check Media
than transparencies when the
Type
Paper Type setting in the printer
driver is Transparency. The
printer ejects the sheet without
printing on it. Load
transparencies into the
specified paper source, then
press the Continue button.
The paper size setting is different
Check Paper
Size
from the size of paper loaded in
the printer. Check to see if the
correct size of paper is loaded
in the specified paper source,
then press the Continue button.
20
20
20
20
Advertisement
