National Cycle N920 Installation And Owner's Manual

PARTS LIST
Description
Lightbar Assembly, N920 or N920E
Connectors, Scotchlok
PREPARATION
1. Remove Headlight from Headlight Shell (Screwdriver), set
aside.
2. Remove Turnsignals:
A. Remove the Turnsignal mounting clamp assemblies
(Hex Key, 5mm).
B. Remove Turnsignals from clamps (Hex Key, 5mm).
C. Unplug Turnsignal wires inside Headlight Shell, set
aside, they will not be reused.
D. Reinstall the Turnsignal clamp assemblies without the
Turnsignals.
INSTALLATION
NOTE: An assistant will make steps 1 (A through C) easier.
1. Mount the Light Bar Assembly:
A. Remove the Headlight Shell mounting screws under the
Headlight Shell (12mm Wrench & 12mm Socket Wrench).
B. Place the Light Bar Assembly so the center mount
bracket is between the lower Triple Clamp and the mount
ing bracket for the Headlight Shell.
C. Replace the Headlight Shell mounting screws and nuts.
D. Make sure the Light Bar assembly is centered on the
Triple Clamp, then tighten the Headlight Shell mounting
screws to the manufacturer's specified torque.
2. Wire the Light Bar Assembly:
NOTE: check vertical aim of the lamps. They should
aim approximately 5° downward. If adjustment is
required see "Adjustment" page 2 of this instruction
otherwise proceed with wiring step 2.
A. Route the Light Bar Assembly wires over the Triple Clamp
and into the Headlight Shell.
B. Attach the wires according to the following list (Connectors
& Slip Joint Pliers):
Turnsignal, Left
Turnsignal, Right
Running Light, Left
Running Light, Right
Passing Lamps
3. Reinstall the headlight and rim.
NOTE: Grounding is through the fork and frame.
NOTE: Check local regulations for proper passing lamp operation.
Some states require passing lamps be lit only with hi-beam.
Qty.
1
6
Light Bar Motorcycle
Short Red = Orange
Short Red = Blue
Short Black = Orange/White
Short Black = Blue/White
Long Blue = White (lo beam)
INSTALLATION AND OWNER'S MANUAL
N920 or N920E (European) LIGHT BAR for
Honda® GL 1500 F6 VALKYRIE
NOTE: The service manual may be helpful in the installation.
NOTE: right and left on the motorcycle are determined from the
rider's position.
Position light bar assembly
between the lower triple
clamp and the head light
shell mounting bracket.
Note, Light Bar Wiring Helpful Hints:
The long Blue wire is the main power wire for the spotlights on
the light bar. Connect that to the main power source from the
headlight. Either the High Beam wire or the Low Beam wire.
The choice is your preference. Turn on bike and Check.
The two short RED wires are for the turn signals. One RED wire
for the Left side turn signal and one for the Right side turn signal.
Turn on bike and check.
The two short BLACK wires are for the running lights. One
BLACK wire for the Left side running light and one for the Right
side running light. Turn on bike and check.
The Light Bar attached to the front fork of the motorcycle serves
as the ground in most cases. A precautionary step to insure
proper grounding is to take one of the Green Ground wires from
the existing turn signals and ground that between the Light Bar
Mount and the Triple Tree Bracket.
Always start by doing one side at a time. Preferably the right
side or high side of the bike first.
Through Wire
Page 1 of 2
Screwdriver, #2 Phillips
Socket, 12mm and Ratchet Wrench
Wrench, 12mm
Pliers, Slip Joint
Hex Key, 5mm
Wire From Light Bar
Insert To Stop.
10-110720-000 Rev. A 03/02