Installing Updates For The Home Connect Software; Resetting Home Connect Settings - Bosch KFN96 Series Information For Use

en Home Connect
Press
2.
temperature display (freezer com-
partment) shows .
a The temperature display (refriger-
ator compartment) shows a value
between (no reception) and
reception).
Note: The signal strength should be
at least .
Improving the reception
If the signal strength is too weak, the
connection may be interrupted.
Carry out one of the solution op-
▶
tions:
Place the router and refrigerator
‒
closer together.
Ensure that the connection is
‒
not interfered with by screening
walls.
Install a repeater to strengthen
‒
the signal.
10.3 Installing updates for the
Home Connect software
The appliance searches for updates
to the Home Connect software at reg-
ular intervals.
Note: If updates are available, the
temperature display (freezer compart-
ment) shows
To cancel the update and reset the
temperature display (freezer compart-
ment) to the set temperature, press
any touch field.
Press and hold
1.
15 seconds.
a The temperature display (freezer
compartment) shows
Press
2.
temperature display (freezer com-
partment) shows
perature display (refrigerator com-
partment) shows
Press .
3.
20
repeatedly until the
.
for
.
repeatedly until the
and the tem-
.
a The temperature display (refriger-
ator compartment) shows an anim-
ation.
a The update is installed.
a The control panel is locked during
the installation.
(full
a If the installation is successful, the
temperature display (refrigerator
compartment) shows
If the temperature indicator (refri-
4.
gerator compartment) shows
the appliance was unable to install
the update.
Repeat the process at a later
‒
point.
If the update cannot be completed
5.
after several attempts, contact cus-
tomer service → Page 31 .
10.4 Resetting Home Connect
settings
If your appliance experiences con-
nection problems with the WLAN
home network (Wi-Fi) or your appli-
ance wants to log into a different
WLAN home network (Wi-Fi), you can
reset the Home Connect settings.
Press and hold
1.
15 seconds.
a The temperature display (freezer
compartment) shows
Press
2.
temperature display (freezer com-
partment) shows
perature display (refrigerator com-
partment) shows
Press
3.
a The temperature display (refriger-
ator compartment) shows an anim-
ation for approximately 15
seconds.
a The temperature display (refriger-
ator compartment) shows
a The Home Connect settings have
been reset.
.
for
.
repeatedly until the
and the tem-
.
.
,
.