Updating (Flashing) Bios From Your Operating System; Recovering From A Post/Bios Update Failure - Lenovo ThinkCentre M58e 7268 User Manual

Updating (flashing) BIOS from your operating system

Note: Due to the constant improvements made to the Web site, Web page content
1. Go to:
2. Locate the downloadable files for your machine type as follows:
3. Print these instructions. This is very important because they are not on the
4. Click Back to return to the list of files. Carefully follow the printed instructions

Recovering from a POST/BIOS update failure

If power to your computer is interrupted while POST/BIOS is being updated (flash
update), your computer might not restart correctly. If this happens, perform the
following procedure commonly called Boot-block Recovery.
10. Turn on the computer and the monitor. Insert the POST/BIOS update (flash)
11. Turn the computer off and back on again.
12. The recovery session will take two to three minutes. During this time you will
13. Repeat steps 2 through 5.
14. Move the jumper back to the standard position (pin 1 and pin 2).
15. Reinstall the PCI adapter card if removed.
62
User Guide
(including the links referenced in the following procedure) is subject to
change.
http://www.lenovo.com/support
a. In the Enter a product field, type your machine type and click Go →
Continue → Downloads and drivers.
b. Under the BIOS category, click Flash BIOS update.
c. Click the TXT file that contains the installation instructions for the flash
BIOS update (flash from the operating system version).
screen after the download begins.
to download, extract, and install the update.
1. Turn off the computer and any attached devices, such as printers, monitors,
and external drives.
2. Unplug all power cords from electrical outlets, and remove the computer
cover. Refer to "Removing the computer cover" on page 14.
3. Access the system board. Refer to "Removing and installing the front bezel"
on page 16.
4. Locate the Clear CMOS/Recovery jumper on the system board. Refer to
"Locating parts on the system board" on page 11.
5. Remove any cables that impede access to the Clear CMOS/Recovery jumper.
6. Move the jumper from the standard position (pin 1 and pin 2) to pin 2 and
pin 3.
7. Reinstall the PCI adapter card if removed.
8. Reconnect any cables that were disconnected and reinstall the computer cover.
Refer to "Completing the parts replacement" on page 44.
9. Reconnect the power cords for the computer and monitor to electrical outlets.
disc into the optical drive.
hear a series of beeps. After the update session is completed, there will be no
video, the series of beeps will end, and the system will automatically turn off.
Remove the disc from the optical drive before the system completely turns off.