Electrolux EWUD040B8B User Manual page 71

Problem
The compressor operates
continually.
The light does not work.
Too much vibration.
The appliance is noisy.
Water flows on the rear
plate of the appliance.
Water flows inside the
wine cabinet.
Water flows inside the
wine cabinet.
The temperature in the
wine cabinet is too low or
too high.
Possible cause
There is no voltage in the
mains socket.
The circuit breaker trip‐
ped or a blown fuse.
Temperature is set incor‐
rectly.
The room temperature is
too high.
The door is opened too
often.
The door is not closed
correctly.
The light is turned off.
The appliance is not
plugged in.
The circuit breaker trip‐
ped or a blown fuse.
The lamp is defective.
The light button is not op‐
erating.
The appliance is not sup‐
ported properly.
The appliance is not sup‐
ported properly.
During the automatic de‐
frosting process, frost
melts on the rear plate.
The appliance drains are
clogged
Products prevent that
water flows into the water
collector.
The temperature regula‐
tor is not set correctly.
ENGLISH
Solution
Connect a different electrical
appliance to the mains sock‐
et, to check if electricity is
flowing. If not, contact a
qualified electrician.
Turn on the circuit breaker or
change the fuse.
Refer to the "Operation"
chapter.
Refer to the "Installation"
chapter.
Do not keep the door open
longer than necessary.
Refer to the "Closing the
door" section.
Turn on the light. Refer to
the "Light setup" section.
Connect the appliance.
Turn on the circuit breaker or
change the fuse.
Contact the service.
Contact the service.
Check if the appliance
stands stable.
Check if the appliance
stands stable.
This is correct.
Clean the appliance drain
holes Refer to the "Cleaning
the drain" section.
Make sure that products do
not touch the rear plate.
Set a higher or lower tem‐
perature.
71