Advertisement
Every time the thermo-hygro sensor is powered up (for example after a
change of batteries), a random security code is transmitted and this
code must be synchronized with the base station to receive weather
data.
NOTE FOR WWVB RADIO CONTROLLED TIME:
The time and date display is based on the signal provided by the highly
accurate government operated atomic clock in Ft. Collins, Colorado.
This radio-controlled clock does not only provide for the weather
station's time and date display but also functions as the time and date
press any buttons after start up until all sensor
information has been displayed and the radio controlled
time has set. Doing so may interrupt communication
between the sensors and display or interrupt the
WWVB time reception.
1)
Pull away the rain cover of the thermo-hygro
sensor to reveal the three sockets (for the wind
sensor, rain sensor and the base station)
2)
Connect the attached cables of wind and rain
sensors to the corresponding sockets of the
thermo-hygro sensor by clicking them into place
3)
Open the battery cover of the thermo-hygro sensor
located below the three sockets and insert 2 x AA,
IEC LR6, 1.5V batteries and close the cover
4)
Open the base station's battery cover located at
the back of the unit and insert 3 x AA, IEC LR6,
1.5V batteries into the battery compartment and
close the battery cover
4
Advertisement
