Remdisk - LXE 2330 Reference Manual

Data Transfer Methods

REMDISK

REMDISK
/Bxxxx
/COMn
/IRQn
/Tnnn
/H
/U
Examples:
(in CONFIG.SYS)
(in AUTOEXEC.BAT)
Default:
/B115K+ /COM1 /T3
E-EQ-MX1DKRG-B
[/?] [/U] [/T] [/H] [/Bxxxx][+|-] [/COMn] [/IRQn]
Set the baud rate. Choose from 300, 1200, 2400, 19200, 38400, 57600, 115. A '+'
after the BAUD specifies 'packet' style transfers. By default, packet transfers will
be used for all baud rates higher than 9600. Use '-' after the BAUD if REMSERV
is running under Microsoft Windows 95. Both sides must agree on using either '+'
or '-'.
Set the communications port. Choose 1, 2, 3 or 4.
Set the IRQ for the communications port. Choose 3-15.
Set the timeout in seconds. Choose 3-3640, 15 seconds is not unusual for FLASH
drives.
Use Hardware Handshaking for flow control.
Unload REMDISK from memory.
DEVICE=REMDISK.EXE /T15
REMDISK /B9600 /COM2 /T10
MX1 Cradle Reference Guide
51