Address Switches (Except Ks2432A); Finding The Address Switches; Switch Positions For 2 Units Or 2 Groups Of Units - Sanyo C2432A Installation Instructions Manual

5. Address Switches (except KS2432A)

On address switches for KS2432A, please refer to
page 9 in the instruction manual.
If you are installing one indoor unit or one group of
indoor units in the same room, it is necessary for you
to assign each unit its own address so that each can
be operated by its own remote control unit. You assign
the addresses by matching the switch position of each
indoor unit with the switch position of its remote control
unit. The switch of the remote control unit is shown in
Fig. 5-1.

5-1. Finding the Address Switches

Remote Control Unit
Remove the lid by sliding it off. You can see the
switches inside the battery compartment. (Fig. 5-1)
Indoor Unit
Remove the casing, then follow the steps below.
(a) Turn off the Power Switch.
(b) Remove the Grille.
(c) Remove the cover of the Electrical Component Box.
(d) Remove the P.C.B. by pressing the head of each
spacer and pull the P.C.B. up (for wall-mounted
type only).
(e) Pull out the P.C.B. to access the address
switch (Fig. 5-2) (for wall-mounted type only).

5-2. Switch Positions for 2 Units or 2 Groups of Units

Table 5-1 shows the positions you can use for up to 2
units or 2 groups of indoor units installed in the same
room. Two remote control units are necessary to allow
the respective units or group to be controlled indepen-
dently.
Table 5-1
Remote Control
Unit No. Address switch
1 A
2 B
The indoor unit address switch is set at 1-OFF & 2-OFF
position at shipment.
NOTE
An indoor unit cannot be controlled if its remote control
unit is too far away (more than 26 ft.). If the remote
control unit does not work correctly, bring it closer to
the unit being operated and try again. There should be
no obstacles between the remote control unit and the
indoor unit. For this reason, if the remote control unit is
to be used from a fixed position, check the operation
before mounting.
Indoor Unit
Address switch
1 2
OFF OFF
ON ON
P.C.B
TS and XS type
36
S4179694
Address switch is in "A" position
at time of shipment.
Fig. 5-1
P.C.B
KS type
WIRED WIRELESS
R.C.U. Switch
Fig. 5-2
A B
Address
1008_M_I
WIRED WIRELESS
R.C.U. Switch
ON
1 2
Address Switch
(DSW1)
0990_M_I
ON
1 2
Address Switch
(DSW1)
0991_M_I