SECO-LARM ENFORCER VS-1AHHAQ Manual

ENFORCER HDMI Surge Protector
Troubleshooting:
Video image is weak or faded
No video image
Also Available from SECO-LARM:
Video Surge Protector
VS-1V12BQ
PoE Surge Protector
IPV-P188Q
IMPORTANT
: Users and installers of this product are responsible for ensuring this product complies with all national, state, and local laws
and statutes related to monitoring and recording audio and video signals. SECO-LARM will not be held responsible for the use of this product
in violation of any current laws or statutes.
WARNING
: Incorrect mounting which leads to exposure to rain or moisture inside the enclosure could cause a dangerous electric shock,
damage the device, and void the warranty. Do not open the case of this device, as there are no field-serviceable components inside.
WARRANTY
This SECO-LARM product is warranted against defects in material and workmanship while used in normal service for a
:
period of one (1) year from the date of sale to the original consumer customer. SECO-LARM's obligation is limited to the repair or
replacement of any defective part if the unit is returned, transportation prepaid, to SECO-LARM. This Warranty is void if damage is caused by
or attributed to acts of God, physical or electrical misuse or abuse, neglect, repair, or alteration, improper or abnormal usage, or faulty
installation, or if for any other reason SECO-LARM determines that such equipment is not operating properly as a result of causes other than
defects in material and workmanship. The sole obligation of SECO-LARM, and the purchaser's exclusive remedy, shall be limited to
replacement or repair only, at SECO-LARM's option. In no event shall SECO-LARM be liable for any special, collateral, incidental, or
consequential personal or property damages of any kind to the purchaser or anyone else.
NOTICE
The information and specifications printed in this manual are current at the time of publication. However, the SECO-LARM policy is
:
one of continual development and improvement. For this reason, SECO-LARM reserves the right to change specifications without notice.
SECO-LARM is also not responsible for misprints or typographical errors.
Copyright © 2015 SECO-LARM U.S.A., Inc. All rights reserved. This material may not be reproduced or copied, in whole or in part, without the
written permission of SECO-LARM.
U.S.A., Inc.
16842 Millikan Avenue, Irvine, CA 92606
Tel: 800-662-0800 / 949-261-2999 Fax: 949-261-7326
4
• Reduce the cable length—max. 16.4ft (5m) for 1080p, 11.5ft
(3.5m) for 4K2K
• Replace with a higher-grade HDMI cable
• Double-check that the cables were connected properly
• Run a continuity test on all wires in the cable
• Make sure source and the display are powered
• Make sure that there are no problems with the HDMI source,
HDMI cables, or HDMI display by removing the HDMI surge
protector.
IP Surge Protector
IPV-PD88Q
HD-SDI Surge Protector
VS-1V22AQ
Website: www.seco-larm.com
E-mail: sales@seco-larm.com
MiVS-1AHHAQ_141215.docx
SECO-LARM U.S.A., Inc.
• Helps prevent damage to sensitive HDMI equipment such as
players, monitors, and projectors
• Intercepts repeated surges and spikes that could damage
HDMI A/V equipment
• Built-in ESD, EFT
• Reaction speed <1ns
• Passive operation – no external power required
• Includes a 12" (30cm) grounding wire for convenient connection to
ground
PITSW4
VS-1AHHAQ
HDMI Surge Protector
Manual