Advertisement
Advertisement
Table of Contents
Summary of Contents for Cyetus KCB Series
- Page 1 Series Coffee Maker Model：KC5020DA...
-
Page 2: Important Safeguards
IMPORTANT SAFEGUARDS Before using the electrical appliance, the following basic precautions should always be followed including the following: Read all instruction. ( 1 ) ( 2 ) Before using check that the voltage of wall outlet corresponds to rated voltage marked on the rating plate. - Page 3 mesh just boiling). Use handle or knobs. (16) Do not let the coffee maker operate without water. (17) Scalding may occur if the water tank is removed during the brewing cycles. (18) Do not remove the metal funnel when appliance in brewing coffee or when steam and hot water escape from metal funnel and ensure to release the pressure in water tank before removing metal funnel.
- Page 4 longer cord. Longer detachable power-supply cords or extension cords are available and may be used if care is exercised in their use. If a longer detachable power-supply cord or extension cord is used: • The marked electrical rating of the cord set or extension cord should be at least as great as the electrical rating of the appliance;...
-
Page 5: Know Your Coffee Machine
KNOW YOUR COFFEE MACHINE CONTROL PANEL - 4 -... -
Page 6: Before The First Use
STEAM/HOT WATER ILLUSTRATION BEFORE THE FIRST USE Before the first use or the machine has not been used for a long time, you should follow below steps to rinse and warm up the internal pipes of the machine. • Check and ensure that all accessories are complete and not damaged. •... - Page 7 Choose the right coffee powder Coffee powder The coffee should be freshly ground and subjected to deep roasting. You may need to use French or espresso roasted coffee powder for espresso coffee. Pre-ground coffee powder can only keep the aroma for 7 to 8 days unless it is stored in a sealed container, and place it in a cool place.
- Page 8 OPERATION INSTRUCTION I. Brew coffee, hot water and steam • Fill the water tank with drinking water, the water level should not exceed the "MAX" position. • Plug in the power and press the ON/OFF button “ ” (make sure the knob is at “...
- Page 9 Brew double-cup of coffee: In the standby mode, install the double-cup filter into the portafilter, load about 19 grams of coffee powder, use the coffee tamper and press the coffee powder with a force of about 12.5Kg, then align the portafilter to the portafilter bracket, turn the portafilter counterclockwise to lock it.
- Page 10 • To ensure good foaming effect of milk, wait the steam runs for 3-5 seconds, and then turn the knob to the twelve o'clock position, extend the steam tube into the milk, and turn the knob to steam indicator to froth the milk. •...
- Page 11 When extracting coffee, make sure that the portafilter is turned counterclockwise into the correct position as shown in the Figures below. Steam function: Under the standby mode, turn the knob to “ ”, the machine enters into steam-making mode, at that time, the “ ”...
- Page 12 Suggestion: We suggest that you can preheat the appliance, including the portafilter, filters and cup before brewing coffee, so that the coffee will not be affected by the coldness of appliance. The specific operation is as below: Put the filter into the portafilter and then install the portafilter onto the portafilter bracket, put a cup well in position and press Single-cup button “...
- Page 13 There are markings to show the coffee coarseness on bean box, see Fig. 3. To adjust the grind setting, make sure the coffee grind setting you want on the bean box is aligned with the mark position on the top cover (as shown in Fig. 4). Fig.
- Page 14 Single-cup(Grind) button “ ” Press the Single-cup (Grind) button“ ” , its corresponding indicator flashes and “ ”、“ ” indicators turn off, the grinder starts to run. And the grinder will stop running automatically after the set ground coffee amount is reached, and you can press the Single-cup (Grind) button “...
- Page 15 Tamp the coffee powder down- When the edge of tamper aligns to edge wards. of portafilter, the powder amount is appropriate. Turn the portafilter counterclockwise into the portafilter bracket, and select the corresponding Single-cup button (Coffee) “ ” or Double-cup button (Coffee) “...
- Page 16 Adjustment for grinding time of Single-cup (Grind) button “ ” : You can set the grinding time as per your need by following the operation as below: Hold and press the Single-cup (Grind) button “ ”, its corresponding indicator and “...
- Page 17 heard, then the appliance goes back to the standby mode. Special notes: The appliance is equipped with two single-layer filters and two double-layer • filters. The single-layer filters are applicable for finer coffee powder, and it is recom- • mended that the grinding setting shall range between 0 and 15. The double-layer filters are applicable for coarser coffee powder, and it is •...
- Page 18 tors turn off. Press the Single-cup (Coffee) button “ ” and adjust the coffee-extracting temperature to be 94℃, the indicator of Program button “ ” flashes, the indicator of Single-cup (Coffee) button “ ” lights solidly, while other indica- tors turn off. Press the Double-cup (Coffee) button “...
- Page 19 Single-cup filter and double-cup filter can be stored in the tool box as well. The tool box is placed at the left lower part of appliance, where you can pull it out when you remove drip tray from the machine (Fig. 6). Fig.
- Page 20 Cleaning brush The cleaning brush is used for cleaning the grinding system. Following the section of “Clean the grinder”, after removing the bean box and grinding wheel, you can use the cleaning brush to clean the chamber of grinder and the powder channel. Clean the anti-static device and coffee Clean the chamber of grinder and power outlet...
- Page 21 VI. Clean the grinder The grinder may be influenced by coffee beans and some other factors during opera- tion to make the powder outlet channel be blocked. Please clean the powder outlet channel in time when the following conditions occur: Clean the powder outlet and grinder at least once every two weeks.
- Page 22 (Grind) “ ” , let the grinder run to sweep out the powder residue in the grinding chamber. (If powder inside is not removed completely, please repeat step 3 and 4) • Remove the bean box counterclockwise and install the grinding wheel well in position.
-
Page 23: Descaling Instructions
VIII. Descaling instructions It is recommended to perform descaling every 4-6 months. Descaling can be selected: A. Coffee machine descaling tablets B. Liquid descaler C. White vinegar and warm water Descaling cycle The descaling cycle takes about 10 minutes. NOTE: After the descaling reminder starts or before the user starts the descaling program, please complete the following descaling preparations before running the descaling program! - Page 24 Place a container Place a container (1 liter) under the brewing head and another container (1 liter) under the steam tube. After completing the above steps, you can start the cleaning process as follow- ing: When the system detects that the flow amount of the whole machine reaches 15L, the descaling indicator will flash, which means the appliance needs to be performed descaling, at that time, you can activate the descaling function manu- ally.
- Page 25 Step 2: Prepare to clean up Important: A maximum of 5 minutes is allowed to take to complete the following steps before exiting from the descaling cycle. The steam tube and brewing head need to be cleaned with fresh water for removing the descaling solution.
-
Page 26: Cleaning And Maintenance
NOTE: • The reminder will appear when coffee powder is too fine and the machine cannot brew coffee. • The buzzer sounds only 5 times and will not sound for a long time. • If there is no operation one minute after reminding, the machine will enter into standby mode. -
Page 27: Troubleshooting
TROUBLESHOOTING Malfunction Reason Solution No indication. Check that the plug is in Insert the power plug, place and ON/OFF make sure you press the button is pressed. ON/OFF button. The indicator on the front The bean box is not Install the bean box panel of the machine is installed. - Page 28 No coffee comes out Excessive amount of The amount of powder from portafilter, or coffee powder, the should not exceed the coffee does not come coffee powder is too fine standard amount. Adjust out from portafilter or the pressure for the grinding setting of smoothly, or the tamping coffee powder...
-
Page 29: Product Specification
If you do not find the cause of the problem, please do not disassemble the machine by yourself and contact your local maintenance agency. PRODUCT SPECIFICATION Product model KC5020DA Item number CYK7601 Rated voltage 120V~60Hz Rated power 1450W Executive standard UL1082 ENVIRONMENTAL PROTECTION You can help protect the environment! - Page 30 Made for Tasty Hobby @ Cyetus www.cyetus.com Starship Electronic Commerce Company Limited Due to continued product improvement, the products illustrated/photographed in this booklet may vary slightly from the actual product.