Motorola C1 Manual page 9

Connecting the handset and charger
(for multi-pack only)
If you have purchased a multiple pack, you will need to carry out this process
for all the handsets and chargers.
1. Plug the power adaptor into the socket marked
the charger and plug the other end into the mains power wall socket.
2. Remove the battery cover from the back of the handset and insert the
2 x AAA NiMH rechargeable batteries supplied. Please note the '+' and
'-' markings inside the battery compartment and insert in the correct
direction.
3. Slide the battery cover back into place.
4. If you are charging the batteries for the first time, place the handset on
the charger to charge for at least 24 hours continuously.
5. When the handset is fully charged,
display. The display will show
indicate that it is registered to the base.
IMPORTANT
Warning! Use only the approved rechargeable Ni-MH battery cells (2 x AAA
Ni-MH 450mA rechargeable batteries) supplied with your C1.
BATTERY LOW WARNING
If icon flashes on the display and you hear a warning beep every
minute during a call, you will need to recharge the handset before you can
use it again.
When charging,
BATTERY PERFORMANCE
In ideal conditions, fully charged batteries should give up to 10 hours talk
time or up to 200 hours standby time on a single charge.
HANDSET
icon will scroll on the display.
on the underside of
icon will appear steady on the
and handset number (e.g. 2) to
1
9
Getting started