D-Link DCS-6500LHV2 User Manual page 16

Section 3 - mydlink
1 Device Name
2 Privacy Mode
3 Motion Settings
4 Point to Go
5 Auto Home
6 Storage
7 Camera Microphone
8 Night Vision
9 Anti-Flicker
10 Invert Image
11 Pan-Tilt Control
12 Status LED
13 Designated Contact
14 Wi-Fi
15 Time Zone
16 Firmware
17 MAC ID
18 Restart Device
19 Remove Device
D-Link DCS-6500LHV2 User Manual
Tap to change the device's name.
Tap to enable. Privacy mode will disable the camera feed.
Tap to set the Motion area and sensitivity settings.
This photo is what you will see when you control your viewpoint in the camera's Point
to Go live-view. Tap Scan to scan a new panorama.
Enable this to automatically return your camera to the set 'Home Point' after 60 seconds
of inactivity.
Tap to change the video clips storage location from the microSD card to the cloud. You
can also subscribe to mydlink Cloud from here and view your current subscription plan.
Tap to enable or disable picking up sound near your camera in live view and recordings.
Tap to change night vision detection to On, Off or Auto.
Reduces flicker in the video. Tap 50 Hz or 60 Hz depending on the frequency of your
lights.
Enable this to invert the camera view.
Choose whether to control your camera's Point to Go live-view pan-tilt control by
swiping or tapping.
Disabling this will turn off the LED until you turn it back on.
Tap here to add, remove, or edit designated contacts that appear in the rich notification.
This displays the current wireless network. Note: Tap Remove Device or press
the reset button if you want to change wireless networks.
Select the time zone to calibrate your device to.
This displays the installed version of the firmware on your device. Tap to enter the
update settings. You can choose the most suitable time for automatic updates.
Identifies the device for support issues.
Tap this button to restart the device.
Tap this button to disconnect this device from your mydlink account.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
13